Adjustable Mold Housing Kit for Silicone Mold Making - Leak-Proof Plastic Frame for DIY Resin, Candle, and Soap Molds - Reusable Craft Holder with Free Combination Design for Jewelry & Epoxy Casting

The media could not be loaded. Curing shouldn't take as long as some reviews complain about. Either they had a bad batch, added too much pigment, or didn't mix it completely.Mix it until there is only one green color. No streaks of white. No spots of light or dark green. Mix it for a couple minutes like the instructions tell you and you'll have no complaints.I only used it for the 75ml cube in the photo and I'm sure larger batches will require longer mixing. You'll have over an hour before it shows any signs of setting so you'll have enough time.After properly curing, there were no bubbles or wet spots throughout the cube. There was a tacky feeling like new rubber or silicone as you'd expect. As you handle it, the silicone mold will pick up dirt and oils from your hands and lose its stickiness like tape does. If you want to get rid of the feeling faster, throw some baby powder on it or rub it on your pants. It'll pick up the fabric and lose any stickyness.I used it to make a tab for an AC return vent screen. After I made the mold, I used JB Weld for the copy. Even without mold release, I could easily remove the copy. It's not a complex part but it was able to pick up fine texture details like where the paint on the original was chipped. The silicone is also strong enough to cut open, grab the part, and snap back into place for another copy.Any imperfections in the copy were from my lazy mold making and not getting the bubbles out from under the part. There was some cleanup involved, but a little extra shaking or prep work would have saved me time trimming later.The mold walls are convenient, but use better tape or another method to seal the bottom and sides. The silicone is very low viscosity and will pick up tiny details. It'll also find every little crack and try to pour out.

Quality is good & all the parts needed for a mold to be poured

Value for what I paid is not horrible. It says Seamless design and that is Not accurate, even the molding has places where it's not flat. The pieces do not fit well enough together, nothing you put in here is going to come out flat or even. There is no bottom to it either. Terrible quality. Relatively easy to put together If you are coordinated. Bought for a resin project, but this is to make a silicone mold Not to be used with Resin. Will be returning.

For a product that states a 1:1 mixture you might think the two parts would have equal amounts, which they didn't, in both purchases I've made.The product itself does work fine, just mix longer than you think you might have to and you shouldn't have any issues.The picture showing food grade and the note saying not for use in contact with food should be clarified to greater extent!

It will do great !!! Hard plastic fits well together.Need larger area buy a few kits very affordable.I had tried other things like taping which was notsturdy enough for my designs. Get this!!!

work like it should but glue them down, to stop any leaks.

So how do you put it together? Ok I figured that out. What is the tape for and how do you use it? What do you use as a bottom? Any dos and don'ts? Better know what your doing if you buy this. Looked all over online for instructions and couldn't find any. Do not recommend for beginners

Exactly what I was looking for. Items clip together nicely, there are some moulding left-over points which were easily removed with a craft knife.