Horande Keyless Entry Remote Key Fob Case Fits for Land Rover Range Rover Sport LR2 LR4 Evoque Key Fob Shell for Jaguar XF XJ XJL XE Key Fob Case Shell

it worked on my 2016 Land Rover Discovery Sport key. My key cover broke off and aluminum end fell off. This worked great.

Good material. Very similar to the original key. The only difference is that it doesn't say Land Rover and it's not waterproof. Very satisfied with the purchase.

We have a 2016 LR4. Perhaps the keys look exactly the same, but upon close inspection there are some minor differences in how each key was made. I was able to get the guts of the key fob to fit, but had to pull out an exacto knife and cut up the inside of the plastic as there were two plastic “tabs” that prohibited the guts to fit inside the plastic shell. Most worrisome was the fear of cutting my finger open as it’s a very small part and hard to hold while cutting out the tab. Other than that, appears it fits after those tabs are cut out / removed. It definitely is a huge improvement on the original key fob in which the glued on plastic cover was coming off and made the key really sticky.

My Jaguar remote, like many suffered the silicone cover separation syndrome. I thought I was doomed to purchase a new remote, although the remote worked perfectly. Enter this amazing life, and money, saver. It's very easy to fit to the old electronics in the case. A very detailed explanation is on Amazon by a previous buyer. Simply pry apart the old case and the new case, pry out the electronics very carefully from the old remote (caution is the word because if you crack the printed circuit there goes about $400 out the window). I pried gently up from the side with no pins so I could work a micro screwdriver under each retaining pin. Gently pry up and the pin will snap and do this with the other pin. Lift out the PC board and the plastic guard (be sure the pins are out of the circuit board...you should see two holes) and press the board and plastic shield gently into the new case, carefully aligning the pins with the open holes on the circuit board. You do not need to glue or otherwise secure the board inside the new case, although that can be easily done by heating a very small nail or sharp object and touching the two pins to melt the top. Again, not required, but be aware the circuit board will fall out next time you change the battery. I should mention...change the CR2032 battery at this time and your remote should be good for several years. Snap the halves together, replace your emergency key and slide the chrome piece in place. (It is a difficult tight fit so I gently tapped mine in place with a rubber mallet. ) You can use your old Jaguar or Land Rover chrome piece as I did if you wish.Can you tell which is the new and old from the picture? The original spare is on top and the new is on the bottom and it works great!

The parts do not fit together properly. The parts are not Rover branded. The parts do not fully integrate/interchange with Rover parts. SPEND $6 MORE AND GET A GENUINE PRODUCT!