WiFi Antenna 8dBi RP-SMA Male 2.4Ghz 5.8Ghz Dual Band + 10in U.FL IPX MHF4 to RP SMA Female Extension Cable for M.2 NGFF + Computer Back Slot Cover Bracket

The antennas work perfectly and easy to install.

I had one of the two cables damaged in my package and they were very quick with a refund. The one that was not damaged works very well and improved my internet speeds substantially compared to a wifi repeater w/ ethernet.

Tried a slightly cheaper set of antenna that would not connect to the card due to problems with the wires. However these worked great, went on the card first try with very minimal effort. Didn't use the back plate, as motherboard already had locations for the antenna to hardware, but it was easy to remove the backplate and attach to motherboard spots instead.Overall good value for the money, defintely watch which brand you get as the antenna wires can make the installation miserable. This ones worked 100% without any issues though, defintely would recommend these.

I used this to allow me to change my desktop case. The old HP case I had came with a built in antenna into the case and wasn't removable without breaking things. The motherboard had a M.2 style WiFi card so this fit perfectly on that card and has given me fantastic signal since installing. I think it's even better signal than the built in antennas were because these are bigger too.Do be careful though, have patience with plugging the wires into the WiFi card as they're super tiny and difficult to line up but after a minute you'll be good to go. It's a one-and-done type job so I don't plan on having to reinstall this again so it wasn't a big deal.

Come well package. Plenty of cabe link to make a clean run.

My signal improved immediately and after a couple of weeks I've had no connection issues. The only real problem is the swivels for the antennas are pretty loose which causes the antennas to flop down. I may try wrapping a few strands of dental floss around and into the swivels to help tighten them.These were difficult for me to attach to the Wi-Fi card. Large fingers and tiny connections are not a good match.

While not an easy install it was problem free and not difficult due to my experience

Connected the antenna to my new Intel Wireless-AC 9560 that I bought to replace my PCIe Wireless and bluetooth combo card which only gave me a 60% WiFi signal and kept having interference problems with bluetooth devices. Only had a very minor shipping issue that very slightly bent one of the wire connectors that plugged into my card which was corrected by just gently rocking it back and forth on the connector on the card until it snapped into place. Despite high power interference surrounding the antenna, I receive a 100% WiFi signal to my home network that's located clear at the other end of my house and I get a 100% bluetooth signal through out the back half of my house where my computer is.