iCrimp Ratchet Wire Crimping tool kit w/ 5 Interchangeable Jaws,Wire Striper&Cutter for Insulated and Non-Insulated Terminals 0.5-35mm ² Oxford bag packing

Good

These were great. The reason I bought them was because I did not know the exact connectors I would be using on a simple repair for you. A friend's vehicle. The connectors on his starter corroded I bought a connector kit of various sizes and gauges so I needed a crimper that had various accommodations for wire gauges.. this worked great and the quality is very durable. I bought another one. I now have two. Juan for the house and another for my RV

Buena calidad y muy funcional!

na jaar gebruik, nog steeds een goede tang. knijpt makkelijk

De buena calidad y muy fácil de usar

My only regret is that I didn't buy this set sooner.At my workplace I had to constantly borrow tools in order to crimp Delphi weatherpack/metripack style terminals, and the crimp tools that I used were extremely basic non-ratcheting types. This made it fairly time consuming to crimp terminals because I had to essentially hold the wire and the terminal together while positioning the tool and crimping it. I finally caved and bought this set.To say that it made my life easier is an understatement. The ratchet action and big handles makes it trivial to get a proper crimp- simply place the terminal and ratchet until it holds the terminal in place, slip the wire through and then squeeze the handles. You get a proper crimp that is positioned where you want it when the jaws release, and it places no additional stress on your hands.The wire strippers are very decent. Chunky handles, a light spring and sharp edge makes it fairly easy to strip insulation, and the lock is pretty handy for storage.Keep in mind that the A03BC jaw set works for the terminal to wire connection on Delphi metripack/weatherpack connectors, however there is no specific jaw for 'crimping' the rubber seal at the end of the terminal (which requires a perfectly round crimp jaw). The picture shows just the wire interface crimped with the seal uncrimped. I found the A10 10AWG hole to work well enough however. I have not tested any of the other crimp jaws but will update this review if required.Overall, I highly recommend this tool. It feels like a quality piece for something so inexpensive, and it actually made the experience of wiring actually fun and relaxing.EDIT 8/10/2017: I used this crimper with the cheap red/blue/yellow terminals. Usually these things are junk because they never crimp properly- and I think most people simply solder them. However, I crimped them with this today using the A30J jaws and the results were fantastic. While this doesn't make the square imprint that specialty crimpers would have, the crimp was strong enough that I couldn't pull the wire back out; the plastic insulation was also shaped so that the end 'cupped' the wire properly. If anything, this was even more impressive than the Metripack crimps I did earlier.