PD Tool Box Liner Professional Grade, 16" x 16 ft (40cm x 4.8m), Black | Non Slip Matting Roll, Tool Box Drawer Liner for Tool Drawer and Tool Cabinets, Toolbox Liners, Anti Slip Mat Roll

Used it to line my toolboxes.Nice quality, easy to cut accurately, and simple to fit into each toolbox compartment.It has an ever so slightly tackiness to it (in a good way) so that it stays in place once you've popped it in.Tools roll around less and also make much less noise when dropping things back into it.The liner does get indents over time if you leave a heavy tool in the same place for several weeks. A couple of my hammers have left slight hammer-shapes in the liner but nothing serious as it's doesn't push all the way through.

Recently purchased this heavy duty drawer liner as my hubby needed to renew all the drawer liners in his work tool box. He’s not finished it all as yet but would purchase more if needed. Says it’s better than the original liners that came with the box.

Fantastic quality, bought to replace the old drawer protectors in my tool box and this stuff is 100%, easy to install and quality is great even for heavier tools etc

Really nice to work with easy to cut and lays flat right away, not quite as tough as some products so I’m not sure I would be happy to use in a tool chest however it’s great in cupboard drawers etc, only downside is the e last metre is so tightly wound it doesn’t flatten properly which is a bit of a con, when you buy 5 metres you expect to be able to use 5 metres not 4 or 4 1/2

For the difference in cost don’t waste money on cheaper products this one is just fantastic. I used it to line a set of office drawers. Its stops things sliding around and dampens the sound. I will use some more of it in a tool box soon. Fantastic product. Be careful when cutting it to size as the pattern in the material cannot be used for alignment.

Excellent material lining tool box draws

This stuff ticks all the boxes.. Once it’s in the drawer, it’s not going anywhere and neither are your tools. It’s definitely on the more expensive side when compared to others but personally, I wanted the best stuff I could find for my tools and toolbox.The 40cm x 4.8m was enough for the 5 small drawers, 2 large drawers and the top compartment in the top chest of my 1993 40” Snap On top chest. It wasn’t wide enough to fit in the top compartment or larger drawers in one piece but, if you cut it perfectly, it’s hardly noticeable it’s in two pieces.Would definitely recommend it. Hopefully the pictures and comments help

This was required to line the draws and cabinet of my new tool box , the length of the roll was long enough for the task and there was just a few off cuts , that l will use elsewhere, the liner does the job very well at keeping my tools in place , no more rattling about when opening and closing the draws. the liner material was easy to cut to the required lengths and lay flat without any issues .