M MINGLE Gutter Cleaner Attachment, Pivoting Coupler for Pressure Washer Nozzle, 240 Degree Rotation, 1/4 Inch Quick Connect, 4500 PSI

This unit is heavily built, but would not hold either turbo nozzle or variable nozzle that came with machine in place. The angle moved under pressure, plus rotated. May work if tightened, not instructions on how do that. The small nozzle i had blew out, think that my fault. Good concept, but execution was lacking.Update customer service is sending new one, great service they reach out to me, I did not have contact them. They Say this coupler should not be used with turbo nozzle. The new nozzle stays in place and does excellent job. Only negative is wish they said in description not to use a turbo nozzle. Note if using a 3000 psi washer about 6 feet is the most you use the coupler at 90 degree angle, just because of pressure to hold in place, nothing to do with coupler.

I needed to pressure wash the outside of my deck railing and this thing does the trick. Just word of caution, an object in motion..... Yeah just hold onto the rod as the pressure will try to force the entire wand the other way.It's a quick release, so make sure your wand can accommodate it.

This multi-angle attachment and feels and looks well built, the detent holds your chosen angle well.The problem with ay angle attachment is that it pushes strongly, through jet action, in the opposite direction of the spray. So you must be prepared to counter this force, which is tiring.Another problem is that the quick disconnect system allows rotation about its axis. To keep control of this rotation, I made a long-handled holder our of PVC pipe that allowed my second hand to control rotation of the device. Basically I glued a 90 degree fitting on 3/4 inch pipe, and cut a 5/8 inch slot that allowed it to slide over the square base section. I then wired it in place. This worked well for cleaning the bottom of my boat.

Have only use once but it is well built. One thing to remember it will turn until you turn the pressure water on.

This product is very adjustable, doesn't leak and is reasonably priced. Worked with my pressure washer equipment. The quick connect function as good as expected and is easy to use.

I was a little ruff with it but I’m still disappointed the locking pin is what broke

I used this to get under my solar panels. Works much better than other things I tried.

The angle-set, "pull" spring-pin's design is the weakest point. It is flawed! I gambled and took a chance that I would get a well-made one and be part of the 79% 4 & 5 stars customers. Fairly good odds. But my luck on this purchase just wasn't there. I relatively instantly became part of the 7%, 1 star group of customers for this particular purchase. Before writing this review, I only used the "M MINGLE" a few times coupled with an older Rigid 3000 PSI Subaru engine powered pressure washer. The pressure washer continually works exceptionally well year in, year out without any problems. The M MINGLE's description says it is designed to handle up to 4500 PSI. I also use 4000 PSI rated hoses with zero problems. However, similar to other customers' comments, the M MINGLE I purchased quickly blew apart. For me, its first of many failures occured while pressure washing my concrete driveway apron. Once the pull-pin blows apart and you find the pin parts, it can be reassembled but it will never work right again. Although it will work it will also fail again and again and again. I'm visualizing a few ways to modify and eliminate the pull-pin setup altogether. Changing angles may take a little longer each time but not as long as searching for the pull pin in road base parking areas, or in recycled asphalt areas. I plan to eliminate a few pull pin dimples and use a spring clip or set screw. Gotta be a better way.