ESUPPORT Car Blue Red Green Yellow LED Fog Light Toggle Rocker Switch 4Pin 12V 35A ON Off Bright Rear Front

I'm using this to run driving lights on my truck. I am running my lights through a relay so I just need a small amount of power through this switch to run the relay, and the relay is carrying the power to the lights. I used a previous reviewer's wiring diagram and some trial and error as well. I wanted the indicator light to come on only when the lights were switched on. I did find I only needed one ground wire, not two. The other reviewer may not be using a relay though. Going my route, with a relay, only required one ground at the switch. My diagram is how my switch is wired and it works perfect for me. However before making your connections permanent test everything yourself to make sure it works.Edit: I ended up being very lucky - there was a blank switchplate on my truck (2008 Nissan Frontier) and this switch fit in that space perfectly. Before you go cutting up your dash, if you have any blank switches see if you can use those instead for a more factory clean look.

It fit.

they work good

Using in a 2004 Tacoma. They fit the lower center dash punchouts (in front of shifter by lighter sockets) not perfectly, but the fit looks better than I expected. These are slightly less tall than the Toyota spec but unless you shine a light behind the dash,l and look for a gap, they look stock enough to me I plan to keep them. The build quality is better than I expected, they are very solid with positive action. The blue LED is too bright for me as ai expected, but was surprised to find the red/green/amber lights are the perfect brightness, not too much and they blend in.Overall, these are much more of a satisfying replacement for Toyoya OEM than I expected. I planned to replace when I found better ones, but these are keepers.

I was surprised on how high quality these were for the price. They work great and have that oem look. The only thing I noticed is the blue one is very bright almost blinding at night, so I used a sharpie and it dimmed it down a lot. Over all I would buy again.

Just what I needed. They seem to be made well and they look good. Other than not having the wiring diagram, no complaints. Luckily someone else put a picture in one of their reviews that showed what terminal was for what and which one wasn't used.UPDATE: The switch part is working fine but the light inside has already burnt out. Originally I gave these 5 stars but since the switch I installed didn't even last a month with only about 10 hours of use maybe I dropped the stars down. Other than the light inside the switch they seem to be good quality and functional.

Bought these to run my Hella lights, and they were better than expected. They fit my Subaru OEM bezels great, and their function was better than expected.

I only needed one bit, for roughly same cost of 4 why not get a selection. Used to power my Baja Design squadron fog lights, these switches are great. Nice fit and finish for my 2004 wrx . Yes, Light on switch is super bright! But, thats good because the fog lamps are powered directly from the battery... best not forget to leave those on by mistake!As for figuring out wiring pattern. yes, it takes for a bit of trial and error but - they work folks. I will say, i did once blow a fuse initially so, check that as well during installation. Attached is couple photos I found online to help give clarity to hookup.