Airless Paint Spray Gun with 10 Inch Airless Extension Pole and A 517 Nozzle Tip,Swivel 1/4" Thread for Graco Titan Airless Hose Sprayers. Maximum Pressure 3600PSI(JW-120028)

works as expected

Some say it cannot be disassembled to clean filter but the one I got came apart easy enough. You just have to know the whole handle unscrews, not the inlet fitting. It has a trigger guard made of flat sheet metal that is going to give problems on getting to the filter, I left it in place because the top side of it was under the nozzle fitting and that fitting did not want to budge. So if you unscrew the handle and work it just right, you can get the filter out to clean it by leaving the trigger guard in place ( it has a lot of float even though it is still attached loosely at the top ). The gun performed great for me.

I had to clean the thread up on the gun so the extension would go on. They were dinged on one side pretty bad. Little cutting oil and a nut and impact. Couldn't use thread cutter. Then about 10 min into the first spray the lock for on broke in the middle of spraying. Like a can under the brake pedal. Had to cut it off.Other than that nice. Can't get the filter out yet. Very very hard to get nut loose. Put in water. Might try vice and wrench next. Didn't leak or have any other issues though. Got the filter out. 2 crescent wrenches and a lot of force.

Good part and very fast delivery

The media could not be loaded. Sprayer did not function properly. It leaked paint all over as seen in the video. (in my case, primer.)I double checked everything, and searched around to see if there was some kind of gasket or part that was missed, but didn't appear so. I took a picture of the parts, including the paint gun disassembled, and tip parts above it. No scuffs/gouges/blockages on any critical part that I could see.I realized after I made the video, I did not include the extension in the picture, or usage, but it had the exact same surface as the end of the paint gun, thus not affecting form or function.I ended up rushing to the hardware store to buy a much more pricey gun/tip assembly that worked.I'm disappointed I will have to end up returning this (and spending all that time cleaning it up after not being able to use it).

Did not fit in my Graco.

Aún no lo utilizo pero se lo ve muy bien de buenos materiales

It worked real good, I have run a lot of paint through it without any problems.