Handle Grip for Hi-Lift Jacks & Other Off Road Lift Jacks |Made of Rubber| - Black

Works for the Badland 1.5 ton offroad jack. Time will tell if it holds up, but the quality seems good. Fitment it snug. I used some foam spray window cleaner to install, and it slipped right on.

Fits my old Harbor Freight jack perfectly. Can't imagine what became of the original rubber grip. Now after 30 years I finally got a replacement. Woo hoo.

It is a grip, works great, just do yourself a favor BEFORE you try to install. This fits well, and grips well, inside and out, making installation a huge pain, unless you do one thing, apply a liberal amount of dishwashing liquid inside the grip and then slide it on. No worries, the liquid will go away when it dries and the grip will be stuck on. The other option, soak it in hot water to soften and enlarge it and as quick as you can try to get it forced onto the handle, better have a big rubber mallet handy cause your gonna need it to seat it all the way down. But it is a nice grippy handle.

Great BUY and fit perfectly.

This is a very nice,grippy handle.I put this on my Harbor freight floor jack that had no grip or foam on the handle,and it fit perfectly.Very easy to install,just used a bit of dish soap and twisted it on,once the soap dried up,it is on there very firmly.

For those who gave it a negative review for install or quality, Red Formann (from that 70’s show) has a word for you that starts with “D” and ends with “s”.Anyone with the right mind would know how to install this. That being said I was worried because of the comments when placing my order. I trusted my gut and ordered and I’m glad I did.3 things will help you install this.1. Pull the split cotter pin from the handle and toss it in the trash. Drill out the hole to 1/4 and keep drilling and punch it through the other side. If you wanna make it look nice like me feel free to ream the hole and paint. Then use 1/4 hitch pin from tractor supply half circle. This will allow you to remove the handle for install of handle or just in general.2. Soak the rubber handle in hot water for 5 minutes3. Anyone who’s worked on their bikes or motorcycles knows, you don’t just ram this thing on dry. Use generous amounts of dawn dish soap on the handle and in the rubber gripHaving the handle off the Jack and doing these 3 things the handle slid on no problem at all.Do I wish it was cheaper? Yeah, it should be half the price it is but supply and demand. Who else is offering a good looking rubber handle that will fit a Hi-lift farm jack? I looked and I could barely find anything besides this.Now my jack looks great, I can remove my handle at will and it looks like it should’ve when it came from the factory.

Fit my Harbor Frieght Badland 60 inch farm jack perfectly.

Nice quality rubber handle, nice to use but also keeps the handle from rattling against the jack if you have it in a vehicle.Looks like it would be too small to fit but I deburred the end of the handle tube, warmed the rubber grip and lubed it up with soapy water before pressing it on. Very snug fit.