Aokin 3 Pcs 0.6mm Hardened Steel Nozzles MK8 Nozzles 3D Printer Nozzles and 3 Pcs 0.5mm Stainless Steel Nozzle Cleaning Needles for Creality Ender 3/3 Pro/3 V2, Ender 5/5 Pro, CR-10/10S, Makerbot

Has been working great. I wanted a larger size than my .4. Have not ran any tough filament through, so no comments on that. PLA, PETG, and HS PLA all printed great. No complaints and would buy again.

I bought these in order to run a wood filament requiring a bigger nozzle. I'm still using the first one I installed, and it's standing up to the higher heat.

Used for some wood filament, no sign of wear after printing a few small spools.

Bought these to print helmets faster, and they work as intended. Nothing stupendously good or bad about them, but they do the job quite well.

The media could not be loaded. I bought these tips to replace the factory brass nozzles that came with my 3-D printer. They installed easily and seem to be printing real well right out of the Box. The only downside that I've seen on them is that instead of having a hex design they only have a flat Spot 2 sides. I used these in a Tenlog TL - D3 pro. Don't forget to level your bed. This nozzle is not the exact same size as the one you take out.

I got a 0.6mm to replace my cheap 0.4mm brass nozzle. My print times have been cut in half, and the print quality is amazing with these.

Not impressed. The hardened steel material is a little sus. They say they are but their longevity says that’s a lie. They seem just like chinesium counterfeits.

Have been using it on my Ender 3 V2 neo for over a week now and 0 issues once I reset my z offset and ABLD settings, which is normal for any nozzle swap. Printing almost exclusively PETG, done some vase mode prints at 1.5mm wide on a .6 nozzle (turn speed WAY down and temp WAY up) and it took it like a champ.