🚙 Illuminate Your Adventure!
The PXPART Smoke Lens LED Side Marker Lights for Jeep Wrangler (2007-2017) offer a perfect blend of style and functionality. With a durable design, high-intensity illumination, and easy installation, these lights enhance your vehicle's safety and aesthetic appeal, making them a must-have for any Jeep enthusiast.
Wattage | 4 watts |
Color | Side Marker Lights For JK |
Voltage | 12 Volts |
Fit Type | Vehicle Specific Fit |
Color Temperature | 3000 Kelvin |
Light Source Type | LED |
Specific Uses For Product | Indicator Light |
Package Quantity | 2 |
A**F
They work as advertised
No issues
Y**U
Good
Good
T**
Cuartos jepp
Se ven muy padres y fácil instalación
S**Y
Not sure what all the complaints are about!😡
First off, I read the reviews for this product and several similar ones. I went with these because they were the cheapest and there were similar complaints for all of them. These specifically had some comments saying "they will NOT fit in painted fenders" well they fit for me just fine even with my painted fenders. I had to apply a little pressure to get the fender pin holes lined back up, but it wasnt hard. Honestly, I think these fit better than the OEM ones I replaced them with and I got them installed in less than 30 min. See the pictures. So far they installed easy, they look GREAT, and as long as they hold up I am very pleased with these, and glad I didnt waste $40 on a set of expensive ones.
A**Z
Le quedó muy bien
Desmonte las anteriores y monte estas sin ningún problema, hasta ahora funcionan y se ven muy bien
D**N
High quality if alittle too thick.
installation was easy. The plastic is a good quality. The full light itself however was alittle too thick and it was difficult to reclip the plastics on the fender. A slimer plastic rivet did the trick. Installed on a 2012 jeep jk sahara. All in all ive tried a few different kinds and these are the best.
P**C
Pretty good for the money
Nice lights and they not only look good but no more blown bulbs. I gave it 4 stars on ease of installing because they are not the exact thickness of the OEM lights pulling the fender back over enough so the bottom hole (foward most retainer you had to remove) would not line up to get the retainer back in. I had to slightly enlarge the hole. Considerable elbow grease required. Other than that they are nice lights.
ترست بايلوت
منذ 4 أيام
منذ شهرين