XPEL Door Edge Guard Protection Film Roll, 3/8" x 100' - Car or Truck Doors, Protective Barrier Against Minor Scratches, Paint Chips, Door Edge Impact, and Dings - Prevents Damage and Possible Rust

We bought this for my wife's car. I didn't even know this existed, except I noticed it on my car, the same year and model as hers, but purchased at a different dealership. So we added this to her car to protect the door edges. I was expecting it to fall off after some time since it's basically just sticks on with an adhesive, and we live in central Florida where the sun and heat are brutal in the summer along with a lot of heavy rain. She parks her car outside during the day when she works, so the car is exposed to all of this, and so far (after 4 months) it hasn't started peeling off yet, so hopefully it will continue to last.It was easy to apply -- simply cut to length and stick it on the front edge of the door, then wrap it around and push it down as you move from top to bottom. I had to peel it back a few inches and try again a couple of times while trying to following the curves and folds of the door's body panel, but I was ultimately able to get it on with no folds or bubbling. Since it's clear, it's barely visible unless you look carefully once it's applied.

Xpel has great PPF. A little bit more difficult to cut than other brands but that's good because it offers more protection. I do see the complaints about the product cutting with strands. I didn't notice one or two strands in the pieces that I installed but it wasn't a big deal. I'm sure when cutting a three-quarter inch strip of PPF it would be almost impossible to avoid this. The instructions did not say to install it wet but I installed it just like any other PPF with slip solution and it looks great

Pretty easy to install and you can’t barely see that it’s thereIt works well

great stuff and you get alot of it, it can do a few cars

Purchased for my wife's new 2025 Honda CRV, which has *very* tight door tolerances and would not accept traditional door edging without modifications. Product was easy to cut from the roll and start on the door edge. Quite flexible/stretchy as well. Lifting/resetting was also easy when I put it in the wrong spot. The great thing? With a 100' roll, I was able to re-do my first door when I was unhappy with the results.When applied, the film is nearly invisible. I am very happy that I purchased the width (1/2") and length (100') that I did. Can't wait until a friend or family purchases another new car.

Impossible! This stuff is terrible! The edges of this film is not evenly cut and there are fine “hairs” of material that were not cut away from the edges. It tried using a fingernail to peel the stragglers away, but it’s tedious and not effective. On a red car, it looks terrible and it’s very obvious. I had front end of my car PPF’d with Xpel film and thought this product would be of similar high quality. I cannot believe Xpel would put this product out there with such awful quality control. I’m returning this stuff. It’s too expensive just to tolerate or forget about it.

Excellent product to protect your vehicle's paint. It's very easy to install even on curved or round applications. It curves very well and sticks well.

Like others have said, the edges on the roll aren't the most uniformly cut. While the edges also sometimes string off, I would recommend checking your strip before peeling and applying it. The strings come off pretty easily otherwise.I tried putting this on dry, but it kept leaving adhesive streaks/stripes/smudges underneath. Spray a little water before applying in order to smooth these out and make it much more transparent.Considering that this offers 110 feet of end guard tape, I guess I can't be too upset. Especially since it was my oopsie that caused the need for it!