Tegg 8pcs PJ-307 3.5mm Stereo Jack Socket 5 Pin PCB Mount Female Audio Headphone Socket Connector

Wasn't sure this would fit in my breadboard - it does, and works fine!The ground pin comes bent at an angle, it's meant to be on a pcb and idk how it would be solderedBut, it bends back easily (literally takes 1 second), and the pins were long enough to easily make contact with my breadboard.

Love the product! All my American friends with less than enough fluency in ChinGlis the 5 connecs are: left to right looking down with term side next to you, Line R, Load R, Load L, Line L and the 5th on the opposite side of the connection board is the common connec (ground) to the other 4 terminals.

Two of the five pins are much thicker and don't fit nicely into most of the perf boards I tried them on. A few worked fine but they had larger than normal holes, which means smaller than normal pads so it's a tradeoff. If you're doing a direct replacement for the same part for a repair these should work nicely.They do the job but need a little fiddling.

The media could not be loaded. Works for what it’s advertised for. I think the connection sounds pretty good.

Functionally works as expected. It holds well on printed circuit boards because there are 5 legs to solder to the board. Definitely would recommend or purchase again.

I used these for the TZXDuino board from ProjectAVR. Works great and now i can play tapes for my Spectrum ZX without a cassette deck.....woohoo

Exact replacement for damaged jacks. Needed 2, now have plenty of spares that will more than likely never be used.

Reasonable price. Good quality. I used one for my HiFiBerry DAC.