MOOG K6541 Front Lower Suspension Ball Joint for Chevrolet Silverado 1500

Good fit and look well made. i used on a 1999 silverado and the project turned out well.

Moog is one of those legendary brands that you know your going to find quality in with whatever your replacing. Moog is my go too for anytime I have to replace suspension parts. They are designed and built with perfection. They always fit perfectly and go in easy with everything I’ve ever replaced sometimes they can very a little bit from factory parts but the Moog ones always seem to be built more heavy duty then the factory parts. Plus the grease inserts make them worth the money. The durability of Moog will not dissatisfy you. Please always make sure you have an alignment done anytime you change any suspension parts no matter how minor.

This is a textbook example of why MOOG is trusted in the aftermarket segment. The K6541 ball joint is over-engineered, featuring an impressively thick stud and pre-greased housing. Installation on my Silverado 1500 was smooth, with tolerances matching perfectly to the control arm cavity.Performance after 2,000 km:Zero noise, tight articulation, and no grease leaks despite off-road conditions and heat exposure. The zerk fitting provided ensures easy periodic lubrication, extending lifespan significantly.Critique:None from a mechanical standpoint. However, the supplied castle nut could be improved by adding a corrosion-resistant coating, especially considering regions with salted roads.Overall, a solid, fail-safe upgrade for trucks operating under load or rough terrains.

I love the low-profile boot compared to the OE GM ones where you have to remove before installation.

Perfect fit on a 2007 Silverado 1500 2WD. The OEM ones are a pain to remove, but these insert very easily with a ball joint press. The fact that these are serviceable mean that they should last a very long time (unlike the OEM). They are built very sturdy. My one complaint was that AFTER the installation was finished and everything was put back together, while filling with grease, one of the ball joint dust boots had a hole in the side, so as it began to fill with grease it just squirted out the side from a location that would not likely have been damaged during installation (the dust boot is retracted inside the steel housing until you fill it with grease). I contacted Amazon and they are sending a replacement. I would recommend doing some kind of inspection before you install to prevent completing the job only to find out that one is defective.

Problem solver ball joints . I wanted greaseable ball joints . These moog also have a better boot system .They fit well and were easy to install.

Fit perfect on a 2010 Avalanche 4WD. Boot is part of the ball joint assembly and compact, nice design.

Good quality. I’m only buying Moog ball joints from now on.