Greenergia Extra Large Controller Case for Electric Bike Controller Box Electric Scooter Controller Case Electric Bicycle Conversion Part Electric Motor Controller Box (Large Size:9.84"×4.25"×2.9")

I undertook a project to lower the height of my Amyet S8, and ended up having to move both controllers (dual-motors) from under the seat to the middle of the frame. I chose the X-Large since I needed to fit both controllers and wires in the box, and it worked out perfectly. Great product that I can see working in multiple different applications. I was a little disappointed that it didn't come with multiple different sizes of brackets or screws, but I made it work with a little ingenuity. I would recommend for use in multiple applications. Cheers!

My bike runs dual controllers. That makes for a lot of wires and when you get into the factory box to upgrade or otherwise need to replace a wire, puzzling it all back in was super tight. This box is great for housing two controllers. Still the wires are a challenge due to their bulk but it is so much easier with this housing than the factory one.

I managed to get everything in the box. The controller. Was a bit large, but I managed to squeeze it into the case.

4 star only because it was difficult to find room on a 29in frame. Other wise excellent.

The rings that hold the box to the bike frame, are way to flimsy!! The box itself is good, lots of room decent for the price. Good quality build.. Except for the afore mentioned? Not sure why they would not make this area better? Would only take a little bit thicker, amount of plastic to make it stronger? No clue what they were thinking?

Was not able to use due to wrong size purchased

Used this for my rad rover upgraded controller. Also bought some Velcro so it doesn't rattle around in there. Also got some rubber gramlets to protect where the wires come out of. I did have to remove the back fender for it to fit but I love how clean it looks with this. Will buy again if I upgrade another ebike.

It is a very nice box, but it is too small for my 1000 Watt motor controller. The dimensions made me think it would work, but the interior is obstructed by the features that receive the screws. Still, I'm going to keep it as I'm sure I'll find a use for it one day. It is an enclosure that will fasten to a pole, a need will arise!

Good size. It's not very strong. Some pieces cracked and broke after light use.

This box makes my ebike hub motor controller wiring look super tidy! It was a tight fit but it all fits. 30 amp controller

As described

Great item.much better if they have cable glands.

Well built and easy to install. I wish they had a picture selection of different listed controllers within this controller to show one what size to buy.