Motive Products1820 Double Catch Bottle Kit, 500ml each, Compatible with Motive Products Power Bleeder Attachments

Bled the brakes on 2 different vehicles with this by using the one person method. Works great, convenient.

Fast shipping. The catch bottle works and performs as advertised. There is no suction so left that blank. This works in conjunction with the pressure bottle that you connect to the master cylinder. What I do is suction out the old fluid with a turkey baster or something like that. Then fill it with new fluid, in my case DOT 4, for my BMW i3, then screw down the cap of the pressure bottle on the master cylinder. Attach the Catch bottle to the brake cylinder that is located on the right rear. The one that is the greatest distance from the Master Cylinder.Pressure the system with the pressure bottle to about 10 pounds maybe 12 on the gauge, course again make sure your master cylinder is full of the required brake fluid for your vehicle. (If you want to know what the pressure bottle looks like, just check Motive products.)Go to the right rear cylinder and using a wrench that fits the bleeder valve just crack it open to where you see fluid running into your catch bottle, course you did attach the rubber hose didn't you LOLYou will probably see yellow looking fluid coming from the lines and maybe a few bubbles.Tighten up the valve, and go check the level of fluid in the Master Cylinder, DON'T ALLOW IT TO RUN DRY.If more fluid is required release the pressure on the system and refill the Master Cylinder. CAREFUL, make sure the pressure is released or fluid may spray out, if brake fluid gets on your paint, it will destroy it, and its not very helpful for your either LOL.Once you see new fluid coming from the Right Rear Tighten that bleeder valve and proceed to the left rear, then the right front, and finally the left front. Course these instructions are for Master Cylinders located on the left side, drivers side of the car, they normally are.Its a pretty simple job and saves you a couple of hundred bucks.

Works excellent and not a drop of brake fluid elsewhere

Not bad quality, good value for the money.

A must have when doing a brake job. Makes bleeding brakes and complete brake fluid exchanges a real breeze. With this tool a two person job becomes a one person job. Saves time. Would buy again. Highly recommend.

Yup they are bottles but better than just any bottle. They help you bleed brakes and see whats happening.

It works very good, I would Recomend whoever need to bleed your brake fluid. It was a little pricy for a couple of plastic bottles but gets the job done right.

works