Screen Protector for Sony Alpha A1 A9 A9II A7C A7RIII A7RIV A7III A7SIII A7RII A7SII A7II, Tempered Glass for A73 A7R4 A7R3 RX1RII RX1R RX100M7/5/4 RX10M4/3/2 (Not Compatible A7IV) -2 Pack

Had 0 issues installing this screen protector. Really didn't want to spend more than I needed to and I think this pack was a great value.

This happened to be the closest size screen protector that would fit on my Mares Horizon Dive computer. While I was diving the other day I noticed the screen looked like it banged against something sharp in two spots. It almost looked like someone stabbed my computer with an ice pick in two spot. It looked like my screen was cracked. Looking closer at the computer the cracks ran to the edge of the protector and stopped. This screen protector did its job and did it well. I wish I grabbed a picture of the damaged screen protector, but my service center removed it before shipping unit back when I sent it out for maintenance. This $7 piece of plastic saved the computer on a several thousand dollar re-breather. This came with two protectors and I have installed the second protector. Its as easy as removing the shipping film and dropping it in place. After 4-5 seconds you can see the screen adhere to the device and push the bubbles out on its own. I will defiantly be a repeat buy of this product and recommending to my fellow divers.

This screen protector is pretty easy to install without any issues if you clean your screen good and get rid of any durt specs before applying. The fit will accurate and the display looks much better now and protected.Touchscreen works too.

Typical great quality glass screen protector. When applied properly, it has no air bubbles. Fit perfectly. Coating seems fine with no visible degradation of screen quality.. It seems like it would protect the screen well. With two pieces, I do expect to need to buy another in the future.

Take your time to align it carefully during the application process. If done right, it goes on beautifully. If it is slightly misaligned, apply pressure to the appropriate edge to try and move it on the screen’s surface. I was able to move mine by about 2 millimeters or so. Note that if it is misaligned, you will get air bubbles wherever the protector has ‘overshot’ the screen.Here’s the process I used (I’m right handed BTW):Hold the top and bottom edges with your middle finger and thumb and carefully align the left edge of the protector with the left edge of the screen using your other thumbnail to correctly align as necessary. When it is correctly aligned, gently make contact with the left edge of the protector constantly using your thumbnail to correct, and then let it slowly fall into place. As it falls from left to right, air bubbles should automatically be pushed outwards.

A few issues with this product. The wet wipe was completely dry in both packets. The description mentions it fits A7R5, but it’s smaller on both dimensions.

Protects the display and has a very good fit on the display. Some others tend to not cover very well but this one does a great job

Perfectly fits my camera screen