GuliKit OLED Thumbsticks For Steam Deck, Electromagnetic Joysticks Replacement with Original Touch Sensing, No Soldering, One-Key Calibration (Not for LCD)-SD05

Super easy installation and great quality. I bought these out of necessity from accidental damage to my deck but I am very pleased with these. They're an upgrade to the original hardware that works perfectly with the steam deck oled. Pair these with a simple ifixit kit and you've got an incredibly easy (14 screw) upgrade to you're steam deck.

Installing them is easy, they are fiddly to calibrate the little button is hard to press. Make sure you move the little cable when installing them otherwise it can catch and make noise. You also need to go into desktop mode and calibrate them there too using the console command thumbstick_cal Got my dead zones down to about 3400 couldn't get them fully centre but I think that's coz I didn't take loads of time to get them perfect

Easy to fit with phone repair toolkit. Unscrew the 8 screws. ( dont forget to remove the micro sd before removing the back as I found out it snapping when changing the NVMe card last time) 3 screws and the old pops out after removing the connector and cable. Put the new in slightly to the right and swing in as the top button switch is on the end of the pcb. Screw down and same for the other . Leave back off turn on and press buttons and recalibrate easy enough then screw back on and put card in . Its really that quick and easy. Centres better than oem and feels slightly more feedback on motion. Once calibrated and gyro reset the jitter goes and zero spot on. Will how long they last but so far, spot on.

initially i bought and fitted the handdiy hall effect joysticks .. but for some reason they felt off .. when i replaced them with this i realised then oh boy were they off ... these are far far superior more accurate way easier too set zero point .. fantastic feeling and don't have the weird unwillingness is the only way i can say it im glad i swopped out for these .. brilliant buy

Very solid, but calibrating is quite a painful experience as you have to press a tiny button on the back while booting the steam deck with the back open.

Great replacement to the originals, good tutorials on YouTube for how to swap them out, very easy job. Zero stick drift now and basically 0 dead zone (the point where moving the stick is translated into input)

It worked to replace a busted left trigger on an old LCD.

They are good came packaged well and deliver was fast install was easy when I watched you tube video. The only complaint I have is the left stick is slightly out of allingment but it is not noticeable when playing but It shows up in the allingment tool in the steam OS.

ÓTIMO PRODUTO... RECOMENDO O VENDEDOR!!!

Una maravilla

Remplacement idéal des Joystick de base du SteamDeck OLED, en effet, la techno Hall garantie qu'il ne drifteront jamais. Le remplacement est relativement simple (il faut quand même démonter le Steamdeck, mais ça n'annule pas la garantie si vous faites attention en le faisant), pas de soudure à faire pour récupérer le fonctionnement capacitif du joystick puisqu'ils sont livrés avec leurs propre pad.

Works great, easy install

This was easy to install, I had a slight issue with the left thumbstick and the wire for the capacitive touch sensor. It was catching when I pushed the stick up. After adjusting the position of the wire it seems to have stopped this issue. I'd recommend following a video to help with installation and calibration. The calibration button on the back of the board worked but I got a far more accurate calibration by going through the Konsole. The sticks feel much nicer than stock, and I'm quite happy with the purchase.