Desctription： 1,Support the online switching of 7 languages; 2,Support preview file model display, display model picture in print; 3,The 32 bit high speed ARM chip is used as the main control chip. 4,7.0 inch TFT touch screen, simple operation interface, high sensitivity; 5,Support WIFI function, through mobile APP control or computer web page control, mobile APP suppor 6,The firmware is upgraded by the SD card, and the operation is simple and convenient. 7,Opening logo and all the buttons and other interfaces can be designed by themselves; at most, 13 8,Support broken point playing function, power cut and storage function, fault detection function Package include 1,1XTFT28 2.8-Inch Full-Color Touch Screen 2,1XCable
K**N
Direct replacement...
Working good..!! You must flash first the firmware of your 3d printer...
R**L
Poor firmware support, Poor communication to main board. Avoid
When using the SD card on the screen I kept receiving Error Check Sum Mismatch messages. This was causing the printer to pause sporadically and leave blobs throughout the print. Eventually these prints failed.Investigating on forums this is a known problem, that the manufacture has been informed about and hasn't released an updated firmware to address.The feedback from the mainboard, such as temp, fan speed also has a tendency to be laggy or will freeze sporadically.
P**B
Teaching tech has a screen adapted on Thingiverse
Follow teaching tech’s video to set itThe screen is pretty easy to setup and use creating custom buttons is a doddle and custom ore heat settings
Trustpilot
3 weeks ago
3 weeks ago
