𝙐𝙥𝙜𝙧𝙖𝙙𝙚 Mini Split Stand, Mini Split Stand Ground Mount for 9,000-36,000 BTU, Heavy Duty Mini Split Ground Stand, Mini Split AC Unit Stand Support Up To 450 lbs Mini Split Condenser Stand

Works great, just what I wanted

My contractor can’t figure out how to assemble this stand. No instructions are included. There is no phone number to call for assistance

This stand is perfect for what we need, to keep the outside part of the minisplit AC up and off the ground and to protect from potential water damage. The stand went together pretty well though we were shorted a few hex nuts and had to improvise. The legs are a little out of alignment, one very much so. All of these issues are very very minor and this stand probably warrants a 4.5 star rating if you are equipped to make the few corrections. I like the color, nice and neutral, a good color for what it is going to be supporting.

I used this withthe the legs to connect a mini-split to my RV rack behind the propane tank rack. It was perfect as it allowed to securely hold-down my RV to my existing mesh rack with little effort using the included screws and square frame. 5 stars

This mini split stand made out of good metal, but they included no assembly instructions so it was not easy to figure out what to do and in what order. Also I had issues with the hardware not fitting well with each other. In the end it does stand and feels sturdy, but I do not know if I would buy from this brand again.

This is a very sturdy and strong stand. Be sure to tighten up the hardware or it will wobble, however. The painted finish looks good and I hope it lasts outdoors. Is somewhat adjustable in mounting the unit, so hopefully yours will fit. Packaging was good, and all parts were there. The legs are adjustable about 6" per leg for uneven ground or mounting surface.My only issue is that there are no directions or even a photo to go by for assembly. It would be nice to know which of the bolts and nuts to use in different places. I guessed wrong first time and then had to take is apart again to rebuild it. Also, get some tools. The little stamped metal wrench included is too flimsy to use on the nuts, and it only fits on one of the two nut sizes anyway. It's not useful at all. You'll need a crescent or open-end metric wrench. Also a pliers to flatten the lockwashers down. As they are, they stick up too much to get the cap nuts on the leg bolts. Just squeeze them a little flatter in the pliers and then they fit.

This is a good stand to get your mini split compressor up off the ground so that leaves and debris don't accumulate around it and clog it up, as well as having ants build a mound around it and get inside the unit.Also, if you happen to be in an area that gets snow accumulation, it will prevent it from blocking the coils and causing it to freeze up... believe it or not, we had this happen in Texas 3 years ago during a bad winter storm in January and I had to go out and dig the snow out from around the unit because the heater quit working from freezing up.It also makes it easier to weedeat around the unit and cut the grass from underneath.It's a lot quicker and easier than building a concrete pad and can be adjusted to make up for unlevel ground.Has a good, enameled finish just like the finish on the compressor that should hold up over time and makes for a professional-looking job when you're finished.Easy to assemble and comes with the mounting bolts and rubber isolators to limit vibration sounds from the unit running.Shipped and received fast and is a good deal if you catch it with the coupon, a little better priced than other, similar stands online.No complaints.5- Stars!