12 Pack Sink Clips for Kitchen Sink Installation(Up to 1-1/4 inch)

We bought a workstation style sink. We did not realize that those sinks are made to look good in the ads, not to actually be installed in a counter. The clips that came with the sink were unusable. I am a retired engineer and I can assure you, they were awful and were not made to be installed into US style cabinets. I bought these because it looked like they might work. They did work well on three sides of the sink. The countertop is 1.5" butcher block and the sink fills most of the upper part of the cabinet. On two sides I had to unscrew the clip and attach the upper part to the sink before dropping it into the countertop. Then I was able to re-attach the clasp part from below and tighten it down. There was no room at all on the front size of the sink and I actually had to use a longer screw so the clasp could grip onto the face-frame of the cabinet. These hassles are not the fault of the Dreyoo clips. They are just inherent in trying to squeeze a large sink into such a small space. If you are trying to install a workstation sink, please give these a try. It will still not be easy, but these will at least make it possible.

Very helpful

These worked for me and they stay on well, but one of them stripped when tightening down the sink. The screws just go into plastic. It didn't feel like the one that stripped was any tighter than the others but it happened, and I could not get the stripped one off without pulling the sink out again.

These worked great for our thick butcher block counters.

Dreyoo 12 Pack Stainless Steel Sink Clips, Undermount Sink Clips Compatible with Serene Valley Topmount Sink NSA103, Sink Undermount Clips Easy to Install, Rust Resistant Support Hardware. Appear to be just what I will be needing once wife picks out new sink for bathroom!! Seems to make the task of Installation of new sink an easy job to do. They are made of heavy duty Stainless Steel, don't see any issues!!

They're better than most with a couple of issues. There's a plastic pivot point that the tensioning screw uses as a nut. The plastic is soft and strips out easily. I also had to reshape the spiked side for a deeper grip on the counter. That isn't likely an issue for everyone, but the plastic will be. Get the pack of 10 so you have extras in case you strip any out. They're a good design and I would buy them again unless I find one with a metal pivot pin.

It was a very good deal fits my needs to the kitchen sink easy to install

I ordered these clips because the ones that came with the sink were totally unusable. These were better, but would not tighten to the counter bottom without making some spacer shims so the toughening screw wouldn’t bottom out. I got them in, but I never want to do that again..