Screen Protector for 2021 Ford F-150 12In Navigation Display Tempered Glass F150 SYNC4 Touchscreen Protector Accessories (Matte)

I just picked up my 2022 f-150 and I thought with it having such a HUGE touch screen, that the chances of something scratching it would be pretty high. I purposefully left the factory plastic on until this screen protector arrived to help reduce the scratches, dust and fingerprints, which was a good idea. I read thru some of the comments and complaints about it not having directions, not fitting correctly and to be honest I was a bit worried. It came packaged well and had a small sticker to pull on to remove the cover for the screen side and some wipes and a dust cloth to prepare the screen in case it needed some preparation. Installation could not have been simpler, if one has ever applied a screen protector to a phone it is the same process. The prep work is going to make or break the quality of the final installation. Before pulling the backing off (the sticky side) make sure it fits and practice your motions that you will use to put it against the screen. Make sure nothing is in the way or dust, lint, dog hair, french fries, fingerprints are anywhere on the screen, otherwise it will show in the end. The protector is a tiny bit smaller than the screen keep in mind it might be a fraction of an inch off to one side or the other, but ours is hardly noticeable and the screen works just fine however, try to keep in centered. It works just like a phone screen protector (almost as if it becomes alive) and bonds to the screen. I had one bubble, I ran my finger over it a few times and it was gone when I got in the truck the next morning. I guess the best compliment I can give this product is when my wife got in the truck and asked when I was "going to put the screen protector on." So far, it doesn't show any glare and hasn't affected the radio or navigation performance. It did seem to take a LONG time to get here. It was made in China. I would buy this again. Hopefully I don't have to.

Very easy to install and looks great.

Still I didn't try it but quality is good

No problems with the touch sensitivity. I cleaned my nav once before I got this and put a couple fine scratches on it....I dont notice them anymore with this screen protector.

Overall happy with product. I had left the factory temporary screen cover on for about 3 weeks, corners were starting to lift up. Followed cleaning instructions however do not think it was necessary as my screen was clean, no dirt on cleaning cloth. My challenge was removing 3 air bubbles near the borders. Used a plastic trim tool with gently tapered surface to remove upper and then lower sides then worked from middle to slowly apply screen more uniformly. Recommend trim tool be about 2.5" width with 45* or 60* angle that can lift the borders, take your time and be careful. Thought I would break screen protector. Used the trim tool to partially reapply screen protector. Furnished paper tool was ineffective removing air bubbles therefore used trim tool I had just used installing vent visor. Would estimate screen protector fit has 1/16" gap on all sides therefore important to apply screen protector parallel to top. My first attempt my bottom right corner was outside of screen approximately 1/16" of an inch therfore to had reapply. Surface appears to be anti glare. Would purchase again. Good luck.