2 Wire Switch Controlled Motor Electric Roller Motor Hard Wired 12V DC Motors for RV Electric Roller Shade, Working for 1-3/16" Roller Tube

This was used to create a retrofit/DIY automated rollershade. The roller works well and is quiet. There is a short beep (not too loud) when the roller is activated. The roller has stop and start positions that can be programmed. These seems to come with a pre-set default roll distance of about 12", so you'll need to reset that - don't assume its defective if it only rolls a short distance. There are no brackets included, you will need to purchase those to mount this. The motor has a 7mm slot in it to mount on a bracket, but most brackets, including the ones from Rollerhouse on Amazon are 10mm (so -1/2 star :-). You can use a Dremel to cut down the bracket to fit into the rollerhead if all you can find are the 10mm brackets.The rollerhouse support team was very helpful determining the motor size for my application. They even helped me locate the correct brackets. When I create another set of automated shades, I'll use this again.

I replaced six roller shade motors in our motorcoach with the bad boys. In the two months since then they've worked flawlessly! The programming instructions do suck, I wish these companies would find a FLUENT english translator when developing the instructions instead of using A I.

I have had 5 of these installed for 4 years now. 2 have now failed, and when I try to order additional none of them pair correctly not sure if they have changed. They just beep and do nothing.

Rollerhouse has many replacement options. as long as you are accurate on your measurements, you'll get exactly the correct one. go for PRIME deliveries. My posted picture os my old top and NEW bottom.

Perfect replacement for my MCD shade in my motorhome. I have a long one that goes all the way across the windshield. It doesn't have the second set point with the key on, but that is really not needed, you just bring it down as needed. Simple 2 wire hookup.

Easy to install. Easy to program.

👌

My God this thing is noisy! You have to be very careful of the type of tube your roller has. Mine has a recessed area where the blind attaches, making the ID smaller. The motor fits, but it's off center. Sounds like a tractor outside the window when it runs. So loud.