Hailege 2pcs AS5600 Magnetic Angle Measurement Sensor Magnetic Encoder Module 12Bit High precision with Magnet

The item is sold with improper magnets which caused me much time to discover and I had to order appropriate magnets which cost as much as the product itself. Best buying from companies that know what they are doing.

The solder pads around the connector holes are very small. Plus they don’t appear to be easily wetted by solder, not clear why this is. This means it’s very difficult to solder on the provided connectors, and almost impossible to be sure the joint is reliable because even if the solder adheres to the connector metal it’s not certain it’s adhering to the PCB. I think this is some sort of manufacturing fault as I have soldered literally hundreds of connectors onto PCBs over the last decade and never had this problem before. I just ordered an Adafruit AS5600 Magnetic Angle Sensor from the Pi hut instead; more expensive but looks to be better made and includes pre-soldered connectors.

ATTENTION pour fonctionner en analogique il faut désouder la résistance R4. De plus 1 seul aimant sur 2....je n'allais pas les renvoyer puisque non expédié par Amazon j'aurais dû payer des frais, dommage avec les 2 aimant ca aurai été parfait. Ca fonctionne tres bien mais c'est 3 etoiles pour que les acheteurs lisent mon commentaire sinon ça fonctionne impeccablement.

Wer Winkel schnell und genau erfassen will, kann zu diesen Modulen greifen. Diese lassen sich leicht einbinden und durch die geringe Baugröße fast überall einbauen.

Works well in first trials. Magnet is sub-optimal with 4 mm diameter. Recommended is 6 mm for full sensitiviy.

Looks like the provided magnets were the proper ones (diametrically magnetized, checked with a "magnet paper"). The readings are (in practice) way more accurate than expected (~4096 steps for 360°). It's possible to check the magnet strength relative to the IC by reading the proper registers on the AS5600 side.

J'ai connecté les capteurs a Arduino Uno, Arduino nano ESPP32 et Espressif Wroom. Je n'ai pas réussi à faire fonctionner un quelconque des 4 capteurs que j'avais commandés. Juste le message:"I2C device found at address 0x36 !" avec un des exemples.