3/8"x 5" inch Stainless Steel Standard Strong Wedge Anchor, Fasteners for Concrete (4 pcs)

Use them to anchor handrail to precast concrete steps. No issues. Worked well.

Always like things that work right out of the box. These anchor fasteners are very functional, work and have good clean threads. The fact that they're made of stainless steel is the reason I purchased these over others. Just drill a 5/16" hole at least a quarter of an inch deeper then length of shank going into the hole, then vacuum out the dust the best you can, thread the nut back to last thread or so, then insert into the hole and pound the remainder of the shank flush to the washer and then tighten nut. I used a 1/2" deep socket attached to my cordless impact tool. I did not over tighten. Last tightening was done with hand wrench to get a proper feel.

Used these wedge anchors to mount a new EV charger pedestal to concrete. Easy to install and appear to be a quality product.

It's good.

Well hopefully this stainless steel last a few years before rusting!! As with all anchors make sure to drill proper size hole to allow anchor to tighten properly. In my case these worked great!!

Easy to install. Did not include instructions/guidelines but worked well. Inexpensive compared with galvanized.

When tightening the nuts onto the studs, two of them cold-welded, and the stud sheared as I tried to tighten it. I had to angle grind them off since they were down in a blind hole, and drill new holes an inch to the side. I ended up getting zinc plated anchors from Home Depot. When tightening, make sure that there is no grit or debris on the studs!!

I am installing a swimming Pool hand rail and needed these Stainless Steel 3/8 x 3" wedge anchors for the two surface anchor sockets holding the rail. After drilling and pounding in the first wedge anchor bolt I hand wrench tightened the nut it, but when I tried to remove the nut to mark and install the other two bolts, the nut was stuck on the bolt and could only be removed. It was not easy to pull this wedge anchor out of the concrete and there was some damage to my rail socket and the surface concrete in doing so. I even tried to remove the nut with the anchor in a vise and the stuck nut sheared off. I believe whatever SS material used on these bolts was too soft. - So ordered Simpson Wedge Anchors - same size and in 304 Stainless and just installed the rail today and these wedge anchors worked perfectly with easy nut removal. - I am returning the Horiznext anchors for a refund

pour sécuriser des supports tablettes