DIY CNC 3D Digitizing Touch Probe Upgraded NPN-NC XYZ Axis Edge Finder Waterproof 3 Coordinate Measuring Sensor Kit with 6mm Shank

The product appears to work well. It is apparent that it uses a nonstandard USB type C cable. I tried to make one from a USB type C cable. Power and ground wires were present, but the signal cable did not connect. I am now trying to make a new mail connector with a type USB C breakout board that contains all 24 connections. It would be nice if the seller also provided another custom cable as an available option. I have both a mill and a router that I wish to use it on. Whatever you do, do not try to use a standard USB type C cable. Without modifying it, you will most likely damage your equipment.

This is "Deadly Accurate" it was with in 0.0004" out of the box ... until I crashed it and broke the stylist mount and need to replace it. The thing that helped me decide to purchase this was the parts catalog and the comment "1. if any listed parts needed, feel to con-tact us." Well, I do need a part listed, but nowhere can I find how to contact them .... or who/where to feel. I assume some day someone will tell me how to "feel" to contact them. However ... I did order another one IT IS that Good Mike

Slight adjustment needed out of the box. I am getting repeatable 0.0002” as advertised. Simple to wire in. Currently running on a Tormach PCNC 1100. I will end up buying another probe and adding the tool setter kit.

found this work great and easy to install with Mach3 using Probe-it wizard.