2pcs Finger Pull Router Bits Set 1/2 Inch Shank,Drawer Pull Bit for Wood Finger Grip & Wooden Handle Molding,YG6X Carbide Tipped

These were a good cost for a complete kit

I was looking for some cove shape bits with reasonable pricing. These worked well for my application.

The roundover bits cut cleanly and leave a good surface. The cutters seem to be carbide and are sharp, but they are not arcs of a circle, but just a soft curve -- and they don't complete a full 90 degrees. The roundover dimensions, ⅜, ½ and so on, are only approximations. If that's OK, they work fine. They should be thought of as grooving bits or edge-softening bits.

I purchased these to use on my stepcraft D.840 CNC. Before this I would set the CNC to carve whatever design I had, then roundover the edges with a router after it was completed. Having these bits allows me to add the roundover edge to the cutting profile, and include it in the CNC process. Loving them so far!

Sharp and they held an edge really well, even when making deep cuts.

good price and quality

The large bit broke immediately. I'm very disappointed

They are OK bits - nothing particularly bad, but also nothing particularly great. They cut fine out of the box but would probably benefit from some edge tuneup.But... they may not be what you think they are. Most point cutting round over bits call out their size based on the radius of the roundover they cut, and are something close to a quarter of a circle with allowance made to come down to a sharp point. These cut more of a flatter elliptical profile with a small flat bottom on a couple of the bits and seem to be sized based on the diameter of the cutterhead. You still end up with a nicely rounded edge, just not necessarily where or how you expected it.I find these bits to work better on my CNC in a fluting or carving situation than in an actual edge relief situation.