MOHAVE 2 Pack [Auto Alignment/Dust Removal] Screen Protector for SAMSUNG Galaxy S23 Ultra 5G 6.8″, 3D Curved HD Clear Film, 7H Hybrid Material, 100% Ultrasonic Fingerprint ID Compatible, Case Friendly

Samsung S23 Ultra Bought a Magic John set several months ago. First protector was nice. Protected screen as it should have, had several deep scratches and a gouge in it. Didn't repel finger prints like they said though. Replaced it with a new one. Some junk slipped under it on install so had to trash it. Ordered this set. I have to say, this was easier to put on than the MJ. MJ had some green tray, and you had to pull the cover off of it before install. Not like their blue kit. As for fingerprints, the Mojave Kit shows NONE. Also, MJ protector felt soft and squishy. This feels like a glass protector even though it's film. Screen sensitivity is perfect. I barely touch the screen and reacts flawlessly. The MJ protector was hit and miss over time. Note! When installing, run it through the press a couple of times to make sure it gets the curve covered properly. Had to take the first one off and redo it because the bottom corner flipped up and I pulled it up and flattened it and screwed up the protector.

I never ever write reviews, but I have to for this one. This is the easiest I've ever installed a screen protector in my adult life. Went on perfectly. Zero bubbles, perfect application the first time. Easy to follow instructions, it took less than 5 minutes to install from start to finish. All functions, including fingerprint reader, work just as expected.

I managed to mess up the installation of both screen protectors. I blame myself for one of the failures (or maybe the unclear instructions on Youtube). The second one failed because running the phone back and forth between the roller on top of the case, which is supposed to eject all bubbles, simply did not work as shown in the video (which was the case for the first attempt as well). The roller did a good job -- except for a massive bubble right around the fingerprint area. Using the included squeegee tool to iron it out succeeded in creating a plethora of micro bubbles that simply refused to be ejected. The result: bubbles under my brand new screen protector right where the fingerprint sensor is, making it impossible for the sensor to detect my fingerprint. Honestly I am so frustrated and disappointed I wish I had kept my old screen protector.

I am the technology person for my entire family and my families family so I put on a metric TON of screen protectors. I have purchased and tried so many different screen protectors over the years I feel I'm qualified to leave this review. I'll break it down in sections of what I feel is important both to me and anyone else contemplating installing their own screen protector. #1 ease of installation ⭐️⭐️⭐️⭐️⭐️ the instructions are printed on the back of the box but I'd still recommend either scanning the qr code on the box to watch the installation video or scrolling down their listing to watch it. That said short of someone showing up to your door and physically installing it for you I cannot think of an easier product to use. It is self aligning and dang near self installing. I mean really. It doesn't get any easier. There is no uv glue you're trying like hell to not get into any of the speakers or buttons. There is no need for guide stickers to slap on and constantly try to perfect. It does instruct you to clean your screen with the provided alcohol wipe and dry with the provided microfiber wipe but the process of installation itself will align, remove all the dust and install all at once. Clarity- ⭐️⭐️⭐️⭐️⭐️ there is literally no difference between looking at or using my phone with nothing and using it with this protector. It's literally invisible. Feel- ⭐️⭐️⭐️⭐️⭐️ I have just installed this so I'm not sure the longevity of this but it feels just as smooth as that brand new device feel. Your finger(s) glide over your screen like a puck on an air hockey table. It feels amazing. Fingerprints- ⭐️⭐️⭐️⭐️⭐️ Every Fingerprint I have installed prior to installing this product works flawlessly with no need to remove and add again. Adhesive- ⭐️⭐️⭐️⭐️ this is where the product loses a star for me. I installed 100% by the instructions and took my time (not that you'd need to) to make sure I did this as perfectly as I'm capable of doing. Front, top, bottom and left side are PERFECT, however the right side just shy of the middle looks as though it is missing Adhesive. This is in no way compromising the functionality and usability of this screen protector you can use see it when the screen is off. PRICE- ⭐️⭐️⭐️⭐️⭐️ the price for this product is great and well worth it. I highly recommend and will be buying 7 more of these and installing on the rest of my families devices. Awesome product!!

6 month review of non-privacy version* This was the 4th brand of screen protector I tried on my S23 Ultra, the first 3 sucked, two had the small circle of adhesive on the thumbprint reader and small strips on just the sides, which look awful when watching movies and eventually the sides peeled up and got dust underneath or cracked when lifted up, the 3rd (can't remember the brand) didn't cover the curved glass sides and lifted on the edges within weeks. This screen protector, however, has been AWESOME, I just removed the first one after six months of heavy use in industrial environments, only because I accidentally dug two deep dents in the plastic with the tips of a pair of Mitutoyo calipers, which looked black when the screen was brightly lit, other than that it still looked flawless with perhaps the tiniest bit of dust under a few edges around the perimeter, but the lifted edges were only .020-.030" thousandths of an inch deep (if you can't tell already I'm a machinist by trade😅) and showed no sign of lifting any further, as they had been that way for several months without getting worse. The applicator system is unrivaled, I have never used a better system for applying a screen protector, you just pop your phone into the slot in the jig, thoroughly clean the screen with the included wetwipe, microfiber cloth and dust sticker, set the tabs on the SP film applicator into the holes and tabs in the applicator jig, then pull the adhesive side film tab down, then use the included squeegee to stick it to the screen starting just below the top in the middle of the screen and slide it down all the way down in one movement from top to bottom with firm pressure, then do the sides, then remove the upper protective film and squeegee the small bits at the top and bottom that are held up by the upper protective film (starting inside the areas already pressed down and pushing out toward the edges), then take the phone out and do the curved edges. If you clean your screen well and remove all dust and follow the squeegee procedure you will hardly be able tell there even is a screen protector on it, aside from the little slot at the top where the selfie camera is located, the jig makes everything line up perfectly square and even. I did have to adjust my thumbprint scanner sensitivity up a little higher, but once it was adjusted correctly it works perfectly every time, without any delay or repositioning. The protective film is extremely durable and has some self-healing ability, aside from the severe dents my calipers made (they have extremely sharp tips and are made of hardened stainless steel so no suprise there) there wasn't a single scratch on the rest of the film, and while the oleophobic coating did wear off after a couple months which showed streaks and fingerprints, the screen still felt extremely slick and smooth and was perfectly clear with zero loss of light transmission, I couldn't tell any difference between the old and new one aside from the dents and slightly lifted edges. I can't recommend this screen protector enough, for the S23 Ultra anyways, I would have preferred a sapphire protector but that's not really possible with curved edges, if you have an S23 Ultra this is the one you should get, 11/10 IMO.

The sceen protector went on easily enough but there were air bubbles that would not come out no matter how many times you rolled it. I even used a squeegee to massage the air bubble out but it made the screen protector turn white-ish in that area and it did not look good at all. This isnt the kind of screen protector that you can just lift it up and reset it to get the air bubbles out. It does come with 2 screen protectors but let me tell you that getting the screen protector off was a PAIN! It came off in 2 separate layers both of them very sticky. Anyway I cleaned the phone and made sure there was no dust or hair again and there were still multiple air bubbles under the protector that would not come out with the roller and the squeegee did the same thing. If you can get it on without any air bubbles the quality of the protector looks decent. But yeah only 3 stars because both of the protectors gave me air bubbles that could not be removed while following the instructions.

Excellent job!! I put it on an already cracked phone to get some more life out of it. Because the screen was cracked there wouldnt be any second chances so i'm glad I got something with a very advanced applicator. No air bubbles or anything, I am very impressed! The protector itself is pretty good, its amazing for this application (A phone repair) but im not quite sure how it will hold up long term. The feel is good and the finger print works but its worth mentioning this is a flexible cover and not a glass cover.

So far this has been the most decent screen protector that offers a little bit of protection and doesn't render the fingerprint scanner totally useless. It's like a really thick piece of a film protector. Installation was relatively easy however it wasn't perfect. There are some minor scratches or imperfections near the top of the camera despite trying to squeegee it down. Also, the sides of the film protector lift up. I'm almost positive that has nothing to do with a case but the curved screen. The screen protector market for the s23 ultra is a pain I don't know why nobody can make an excellent case. But this definitely has been the easiest install out of the three cases that I tried (1 was tempered glass with fingerprint island that didn't work. Another was a liquid wet install of glass that failed.) It's decent but nothing extraordinary. I just hate how s23 ultra users have to "settle". Do better people. Edit: taking off a star after a month of use. Sides lift up and random bubbling. Lastly, because the sides cannot adhere to the phone, a lot of dust accumulates. Screen doesn't even look good anymore.

Muy buen producto

After moving from 3 fold phones back to a normal phone I thought I would try one of these "hand" applicators since they have not been around for the fold devices. This is a total load of hot excrement and both attempts even following the videos result in a half baked installation where the "holding film" is still lifted at both ends and allows dust and other particles to get in on moving the device. Do not waste your time or money on this product.

I have installed many screen protectors on phones, but never have I seen one go on so simply. Installation was perfect and it works well with my Otterbox case. My only beef is the lack of an oliophobic coating. I find it retains fingerprints and smudges more than the original surface.

Pretty simple instruction even though I screw up the first one I got the second one done perfectly.. and the protector material are good!

After trying all the top sellers. from glass protector to film protector. I can confirm that this one is perfect. Easy install and simple instruction. You can't miss. Would be nice to have more than 2 film protector in the box. If you get a tiny particle of dust during you install, you only have another chance...But it's not the product fault. Stuff like this can happen.