Rust-Oleum 400ml Stone Spray Paint Aerosol - Bleached Stone

This covers well and is very effective. I used this colour on an outside ornament, that is cement and had discoloured a bit. I then covered it with clear Yacht Varnish to waterproof it, as the paint itself is not waterproof. I have also done the same using the black granite effect paint with a black concrete outdoor pot that was looking very tired, again, overcoat of Yacht varnish to seal and it looks like new. A tin did a large ornament, 2.5 ft high, for a couple of coats. Really makes it look like stone.

So easy to use, shake well for 2 mins, hold 30 cm back and spray is big long lines end to end. I had a oak looking fireplace and wanted to update it abit. I looks and feels like stone. So many compliments on it. I used 3 cans so complete this fireplace allowing each coat half hour to dry, Did final can the following day when i could assess any patches. Covered middle with newspaper and floor, painted it in a base colour as this spray is mainly for texture not colour. I used a single pound tester pot from wilko called oatmeal and it's really lovely if u have neutral decor. Tips : Lightly sand area and wipe first. Spray outside. Cover anything nearby as it does travel some. Spray from a distance or itl clump and look flase, better to do multiple light coats and fully dry inbetween than a few thick coats. Itl pay off with patience. Ive posted b4, during and after for your reference.

This is horrible to apply. Despite shaking the can frequently, the nozzle clogs constantly so you have to stop, take the nozzle off and clear it after every 2-3 seconds of use. It comes out like spray Snow and the finish is disappointing, but I've only managed the first coat so far because it takes so long to apply, with all the stop-starting to unblock the nozzle. Shocked that this is branded as Rustoleum, as other paint I've had from them is such good quality. Overall not for for purpose, and would never buy it again. Avoid!

I used this to give my custom PC a bit more of a subtle edge. The case is a Nouvolo Steck, a modular mini-ITX chassis mostly comprised of aluminium with a matt black finish. No issues with the nozzle or spray pattern, density or anything like that. I wanted to give the case a thick stone / granite finish but decided at the last moment to just try a thin very quick once-over to make it easier to sand off and repaint if it all went wrong but found that I liked the way it looked more. Its mostly black with white and dark grey 'chips' which give it the textured feel. They do flake off under friction but that's because I just did the one half-arsed coat. I laid it on thick on a discarded cylindrical 3d print (unfortunately I don't have a pic) just to see how it stuck to PLA plastic and while it didn't take well to the glossy side of the print I did a rough sanding to one side and it adhered much better and flaked a lot less from just rolling around my desk.

Gives a beautiful stone finish. Definitely worth the money

Good effect but intermittent spray nozzle

Excellent product Very pleased

Beilliant, needed to cover some old planters this was great

Schnell geliefert und in Verbindung mit Haftmittel gut zu verarbeiten.