RadiolinkCL9030 90A (2-4S) Brushed ESC Waterproof Built-in 5A BEC Selectable 5.5V/7.5V Electronic Speed Controller for RC Crawlers Tanks Cars Boats (XT60 Plug)

I've bought ESC's in the past that claimed they were 3s or 4s capable only to have them overheat and stop working. I tried this on 2s initially and it ran fine. My boat is 3s so I tried it but I also added more lights and a water pump and the ESC worked great. I'm confident that it can handle 4s but since my boat is 3s I have insurance that my rescue boat won't get stuck out on the lake and have to be rescued itself. Great product at an even better price, I plan on getting another for my Dodge Viper I'm rebuilding.

very easy to set up only grip is that the rubber covering the wires to the motor is very short so i had to add some to make it more water resistant.

I bought this esc to pair with my Radiolink transmitter and receiver plug them in and they paired up perfectly I think the key is they have to be compatible with each other because I tryed it with another esc and it wouldn’t pair. But I would recommend if you at least pair with the same brand of receiver and transmitter.

everything

I use it for speed control on my Watersnake t24 trolly. It replaces the speed and direction switches on the motor and gives a smoother, more efficient use of the motor. It works great, it doesn't require a special programmer to use, and it is compact enough to fit in the head of the trolling motor. Pair it with the HotRC ds-600 and you have a quick and easy RC speed controller for you trolling motor.Great price, great performance, great product.

I set everything up and plugged in correctly on a Duratrax Evader chassis with stock motor. It worked great for one 5 minute run, and I went inside to do some tweaks to my body mounts and antenna length. Plugged my battery back in, and put it on the ground. It worked normally again for about 30 seconds, then would not go forward or backward. Then I hit forwards on the remote again, and it was locked on full speed, sending it into a wall! I have confirmed that the output on the ESC is now shorted full power all the time! Confirmed that my motor capacitor is not shorted, my motor works fine, and it still works with my old ESC. Very unhappy with this, and now I have to repair my truck! Received a refund and will be buying a different ESC instead

Put it on my Cen F450 haven’t ran it to hard just yet but it’s held up well so far I’ve managed to get it warm but that’s it . That was on 2s and will be seeing how the 3s holds up for that’s what I usually run . I like how quiet it is compared to Cen’s stock one

I couldn’t figure out what was broken on the traxxas 1/10 2wd car, so replaced the radio and esc, using this esc. It works perfectly. It doesn’t mount the same way, but it mounts easily enough in the same spot with a little additional hardware.Cheaper and just as performant as the traxxas parts.