5 Pack UHF PL259 Solder Connector Plug with Reducer for RG8x, RG8, RG59, LMR-400, RG-213 Coaxial Coax Cable，Teflon Material 50ohm Low Loss RFAdapter Compatiable with Ham Radio Antenna (5-Pack)

Not bad at all price is pretty good fairly good quality yeah I'd buy them again

the core of my coax passed right into the center pin. make sure you check this connector with a multi meter BEFORE you solder it.

You can spend a lot or a little for PL259s. Usually, the cheap ones are hard to solder to or the insulator melts with moderate heat. Soldering these are good, not great. You do have to be careful with soldering heat to not melt the insulator. But, with care, you can make these work. For a price far below that of the premium connectors, I think they are ok

Excelente calidad

You must be careful with the center insulation. It's definitely not an Amphenol. You must be very careful with the heat because you can melt it and then you have junk. It will melt quite easily. You get what you pay for. With that said they seem to work okay. Long term in the weather will be another story. But if you're looking for a inexpensive connector this should be just fine. Make sure you wrap it up tight to keep the moisture out. The only thing I could add to keep in mind these things are from China. Only buy from a US seller. That way you can get you money back if your not satisfied. Don't count on Ebay to help. Also always use a credit card so you can reverse charges because like I said, Ebay won't help you. I check very careful after being burned by them. My only advice is to hyst be careful.

Fittings were as expected. Would by again.

insulator is -not- ptfe, melts like nylon, and the threads don't fit anything.

These are pretty cheap. Was surprised when I looked and instead of holes for soldering the braid, it has two rectangular holes. Had to clean it up with a file because there was pretty rough. Be careful when soldering the middle pin because heat does melt the amphenol insulator and it will move the pin. Wait and see how it holds up.

I needed a couple connectors for RG-8X, and these connectors worked fine for that. However, the description stated RG-59 and other sizes and based on the photo, which shows the connectors with the adapters installed, plus 10 additional adapters not installed, so was expecting to get the adapters for a couple different sizes of coax.Otherwise, the connectors appear to be working fine.

good value for the money........product works as described

Units worked well for what they were designed for

I ordered because the description stated Teflon. Went to solder and hardly had any heat on it before it melted. Not a good quality connector.

the reducer bushings are shorter than usual