Black PVC Quadrant Trim,Flexible Laminate Beading Self Adhesive Plastic Wall Corner Edging Strip for Worktop Ceiling Floor,Caulk Moulding Skirting Board Trim(5m,12mm*6mm)

I used this to edge a new floor in my garden room instead of skirting board. I found it easy to cut and put in place but initially it did not stick well to the painted mdf walls. So I borrowed my wife’s hair dryer and heated it as I pressed it firmly home. The result….. a neat, well stuck finish.

Good product although I wish it was stickier. It seems to be okay after fitting but the instructions say to heat with a hairdrier for maximum adhesiveness. I couldn't do that as I'm unattached and bald :/ . However the ambient temperature was around 16C and it seems okay so far. Looks really nice though. As with anything, time will tell.

Bought this strip from another seller (1st photo) and although I liked it, it wasn’t exactly white-white and texture was rubbery so fluff stuck to it easy, then I bought this one (2nd photo) I thought I was getting exactly the same but this is by far better quality as it’s white as if it’s been painted so blends in with my freshly painted skirting much better and also has a sheen so easier to clean too. This seller is well worth saving

I was wary given some of the reviews, however...I got it to allow angling a Philips Hue lightstrip downwards at 45 degrees when mounted at the wall/ceiling 'corner'.The 19mm strip is perfect match for the lightstrip.Cleaned the wall/ceiling with isopropyl alcohol in the mounting area, then attached the strip. The adhesive grabs instantly and really sticks. On a wallpapered surface it's essential to position it into the corner correctly before pressing into place otherwise it may not fully stick to both surfaces, trying to move it will lift/tear the wallpaper.In retrospect it would have been easier with a person helping support the unstuck end of the strip during installation.Also wiped the strip with alcohol before sticking the lightstrip to it.The lightstrip runs warm, but there's no sign that adhesion to the wall/ceiling is affected even with the extra weight of the lightstrip.Edit...after less than a day from fitting, the adhesive failed overnight, the entire length just peeled away and fell down.The adhesive tape had even unstuck from the trim strip itself in many places (this happened with it cold, not with the lightstrip on.)It would not stick back, just unpeel again within a few seconds.As I've got the lightstrip stuck over the top, the simple solution was to remove the lightstrip, secure the trim strip with panel pins, then refit the lightstrip.The adhesive on the lightstrip seems to be much better.

This is absolutely rubbish! Is not self adhesive as described, you don't even buy it if you intend to use it as self adhesive. The is zero star, only clicked on 1 because I can't submit my review if I don't click on the star.

Just renovated our kitchen , and had to have walls replastered. This caused gaps to appear since the walls were not 100% level, This edge strip did the job and matched perfectly with our gloss black units. Looks perfect. Seamlessly blends in as though part of original kitchen.Very easy to cut with utility knife. And is pretty tacky. Good adhesion.Would buy again.

Easy to use. Sticks well.

After reading the comments bought it to use in the bathroom but also ordered a bathroom sealant to act as extra adhesive. Worked like a treat, very easy to install, minimal clean up and tools required. Was not too hard to cut. I recommend leaving it a day to straighten up to make measuring easier.The corners didn't exactly meet flush, but filled it up with filler and Bob's your uncle. Perfect for a DIY project