Gikfun20W Qi Charger Module Coil Car Fast Charging DIY Charger Parts Universal Type-C Interface EK1984

This works surprisingly well. I used this to create a phone charging pocket in my Jeep Gladiator.

I'm making custom 3D printer chargers for family and friends. And despite making several modifications to my design, I could never get this to work when it was behind a 2mm sheet of 3D printer PLA. It would do most phones without a cover, but almost none with a cover. Just not enough power or surface. I ended up going with a dual coil charger and it has yet to NOT charge any phone.

Works

it works with my pixel 6 pro. It has 2 leds red for standby and green for charging they are a little too bright but it works well on my 3d printed phone holder

Measurements were accurate, working as hoped. Be aware, tolerance between phone and disk is VRRY small/tight but charging fine.

Installed this on the underside of the front center seat back next to the cupholders on a 2022 Ford F-150 XLT where the phone-shaped indentation is. Ran a usb-c cable to the rear port, and voila! No permanent modification needed, and wireless charging added for under $20. Took about 10 minutes.Will update over time if heat dissipation becomes an issue...

First off, the label on the unit I received shows that this item is not new, but a return, sold as new. 2nd, the highest wattage output I could get out of it was 5.6w. No where near the 20 watts it advertises. And yes... I used the proper cabling/charge adapters.

It works. I just wish the wires between the board and the coil were longer.