Bob Smith Industries Insta-Cure+ Gap Filling Super Glue CA (1oz)

This stuff is the strongest glue I have ever tried only downside it dried so quick it eventually blocks the nozzle

I found about this glue on YouTube where it was used by a professional cobbler and I've always used traditional super glues with relatively poor success. They don't seem to work on spectacles or some types of plastics this however I haven't had a failure. Everything I've used it on stays stuck it also has a filler in it which means that if you have a slightly ragged joint it will fill that joint and still stick so certainly recommend it

Tried it on a few materials without issue and especially great for 3D Printed Models will buy again

Buy the spray accelerator that goes with it for a powerful duo. Like steel with good gap-filling qualities. Makes Loctite look pathetic.Hint, if you glue your fingers just soak in hot water with a pumice stone!

As a model maker, it's important that you can find an adhesive that actually works, particularly when you use lots of plastic which can be resistant to many glues, including superglue. I discovered this produce watching a YouTube video and it's amazing. I've had no issues with its ability to adhere surfaces and if you dab on some baking powder immediately after applying the glue and bonding both surfaces, it cures practically immediately. It's less messy that traditional superglue and even when you get it on skin, is much easier to clean off. A must have produce for any model makers or crafters.