VIJIM Camera Desk Mount LS011 Set

Very nice design and feels sturdy. The control joints are easy to adjust and the included pieces allow many versatile use cases.I have LED lights on the fixed post and a webcam on the extension arm which can move around.

Eu recomendo a compra do produto, a entrega foi rápida na minha opinião, a qualidade do produto é excelente, praticamente todas as minhas expectativas foram atendidas. A marca do produto é VIJIM.

The VIJIM LS11 is virtually identical to the SmallRIg DT-30 in terms of material, construction, design, dimensions , stability, etc. Both are made in China, most likely by the same manufacturer. The SmallRig DT-30 comes with a small, nylon carrying case that is too small and near useless. The LS11 doesn't come witht the case. Both have identical desktop clamps and both have three identical vertical tube sections that can be adjusted for same height. Both have a 1/4" screw mount ball joint on the top section for your camera or projector. Both come with an extra horizontal arm about a foot long that can be clamped onto the lower tube section or the middle tube section (but not the top 3rd vertical section). This limits the height of the horizontal arm adjustment from 0-24 inches off the desktop. But here is the key difference - the LS11 horizontal arm comes with two separable sections whereas the DT-30 horizontal arm is a fixed length design. One can screw the extra horizontal extension arm on the LS11 screws into the ball joint on the end of the first horizontal section to give extra horizontal extension. Moreover, the extra arm extension can also be screwed into the ball joint at the top of the third vertical section. This gives the LS11 about an extra 11" in total vertical height over the DT-30 (45" versus 34"); or alternately, it allows you to have a second horizontal arm. In short, the LS11 does exactly everything the DT-30 does but also offers almost a foot more adjustment in height or horizontal reach. Using just the first section of the LS11 or DT-30 horizontal arm is very stable and easily supported my 1.5 lb projector. Adding on the second 10" horizontal section onto the LS11 was still ultimately stable with the projector but it had a little initial wobble. Max rating is 2.2 lbs on either the LS11 or DT-30 horizontal arm. I believe that you can safely load 2.2 lbs on either DT30 or LS11 if you are only using the single horizontal section. With two horizontal sections, hanging 2.2 lbs on the LS11 seems doable but a little dicey. There is one small final difference between the two designs. The LS11 first extension tube screws into the desk clamp whereas the the first extension tube on the DT-30 is welded to the clamp. I found no difference in performance or stability. In short, the LS11 is virtually identical to the DT-30 in dimensions, material, paint, and quality. The LS11 and Dt30 perform identically with a single horizontal arm. However, the extra horizontal extension arm that comes with the LS11 gives it added height options and horizontal extension options.

It's sturdy and half of the price of elgato mount that I was thinking of getting. Nice quality all the parts can rotate and move around.

Overall quality is good.The clamp does not tighten in its place (a little wobbly) but gets the job done.Recommend ✅