Clean with a Conscience! 🌍
The Tech Spray 1621-10S EcoLine Flux Remover is a 10 oz can of general-purpose defluxer that is EPA SNAP approved, non-ozone depleting, and safe for most plastics. It features a zero-residue formula that rapidly evaporates, making it an ideal choice for environmentally conscious professionals.
P**X
Flux Remover
I use this at work. It removes all resin flux from circuit boards after making repairs. Highly recommended by me
M**G
EXCELLENT PRODUCT FOR WHAT IT'S INTENDED FOR
I'm building LDC microphones, these have extremely high impedances inside. Just a little flux around one of the critical connections will cause noise and distortion, sometimes B U Z Z Z Z.By taking the time to carefully clean each major solder connection with this chemical (on the end of a Q-tip) I've had 100% success with my microphone construction and builds.Good stuff, strong smell, works great.
R**H
Worked well for my board
I had a large (15x21) board covered with flux residue from soldering. I used most of the can, but it did do a pretty good job of removing all the gunk from the board. Evaporates quickly without much odor, leaves no residue behind.
J**N
Does what it says
Quickly removes rosin and no-clean flux residue.Low odor, quick drying.
B**C
Great cleaning agent
A side from the fumes, works like a champ.
J**N
Horrible value for the money.
Get a spray bottle with 99% alcohol and a soft bristle toothbrush will equal same result. Super overpriced stuff. Never again.
T**L
Product seemed to have been used. Didn’t last at all.
This product work’s excellent, but this can did t last near as long as other cans I have purchased from distributor.
A**R
Too expensive.....use alchohol.
Too expensive......was just as easy and much cheaper to use a bottle of alchohol and an old toothbrush.
Trustpilot
1 day ago
1 week ago
