3M Clear Paint Surface Protection Vinyl Film (6 Inch x 60 Inch)

Was not sure what to expect, but it seems to go one well. Had to trim a little more off than planned, but only a little. Been on now for a few months, and it is holding up extremely well. Live in a rainy climate, and has gone through a couple of car washes already, and no sign of pealing off. Will use again.

This is the best protection for Louboutins I've seen so far! Easy application, lasts a long time and is not slippery. As you can see in the photos, one hasn't ben worn yet and the other has been work about 10 times or more. Still bright red and glossy, barely any signs of wear. After wearing, I wipe the soles with a damp napkin and it works perfectly!Once you apply it, let it sit for a day or 2 so the film adheres completely and it will be almost unnoticeable.

I have metal clad patio doors and a smart young poodle that has learned we open the door using paddle style knobs.Now he tries to work the paddles to come inside despite the fact he has his own "doggie door" two paces away.The result is accumulating shallow, unsightly scratch marks in the metal on the door below the paddles. I wanted something that would protect the metal cladding. A quick search online turned up this product and the videos demonstrating it's use convinced me to try it.It worked perfectly. I also learned that, at least in this application, it is slightly self healing. In other words, slight blemishes such as tiny bubbles or small wrinkles tend to work themselves out.Another upside is the covered surface actually looks better than the original. The biggest disappointment with this product is I don't have another place to use it.

Easy to install. Used it on several bicycles we ride on gravel a lot. Installed it with the wet technique and it’s bomber!

Great adhesion and thickness.

This stuff is HARD to put on cleanly without fingerprints and bubbles. I consider myself handy and meticulous, but I failed at the task of applying this to my curved back bumper horizontal surface. I was protecting new paint and new car from big dog claws jumping in and out of my SUV. The product is thick enough and has some stretch to it. but I was unsuccessful at laying it down dead smooth, and my re-tries created finger prints on the sticky side. It does the job, but if you are not going on a dead flat surface, and can spend a couple hundred dollars, you might be better going to a shop that applies clear bras on cars. Don't get me wrong, this is not 3Ms fault, I just over-reached the task and my expectations. The resulting product will do the job, and looks fine 10 feet away. Just an FYI.

This is really one of the best products I’ve seen and used. I wanted to put some bumper stickers on my car but not have the paint damaged at all and this is just an excellent product. It goes on as Crystal clear and definitely. I feel nice having the car paint protected by this

I used this product to cover inner sill surface on my car to help reduce scuffs to the car vinyl caused by getting in and out of the vehicle. It can be cleanly removed when necessary.The product shipped in a tight roll specific to what I'd ordered (6"x60"). I hung the roll vertically indoors for a couple days with improvised weight at the bottom.The product will tend to curl and stick to itself when the liner is removed so make sure you mist tack solution on sticky side before t has a chance to do so. Mist tack solution to substrate before peeling liner. then mist some on sticky surface. Once applied to substrate, use slip solution on gloss surface of vinyl film and glide flat, smooth-edged bonding tool to remove liquid and bubbles.Slip/tack solution recipes and application techniques are all over YouTube.