Detroit Axle - Pair Front Lower Ball Joints for 2006-2011 Honda Civic, CSX 2007 2008 2009 2010, 2 Lower Ball Joints Replacement

Bought these in a pinch because my standard go-to, Moog, was out of stock. These arrived the next day. They appear to be of similar quality as Moog. I like how they have the grease zerk fitting so you can keep fresh grease in them. They come with two new mounting nuts, a castle nut, and cotter pin. You have to reuse the mounting bolt, but no big deal. I can't say anything about how long they'll last, but I'm impressed thus far.

We got these faster than promised, an everything as expected. Thanks!

Met my needs highly recommend!!

Detroit Axle sells a pair, driver and passenger side ball joints at a very reasonable price. I like that they include a grease fitting, but it's a right angle design, and I found that once I snugged it up it was facing the wrong direction. To get it where I needed it, I'd have to really tighten it and might break it off, or back it off and it would be too loose. I think I'll replace it with one that points straight down. The nuts included (bottom nut in photo) don't have a flared, washer-like side so I'm going to reuse the OEM nuts. A new castle nut and cotter pin are included with each ball joint. They aren't marked as to which side they fit but there is a definite L & R ball joint. Took me a few minutes comparing the old to the new, both look identical when viewed from the top and the bottom, you have to look at them from the side to see which matches the old one from the side you're working on.

Everything Fit as Described

I got these for a Honda Civic 2010. Quality seems ok but quality control is off. I ended up returning for the reason that the screws came warped and would not naturally bolt in. So I decided to go with Honda original parts since it’s a crucial part of the suspension system and I want them to last longer. After market parts simply don’t have the same reputation as OEM. Maybe worth it if you’re in a pinch and want something quickly delivered to you. However I would not recommend for longevity. The rotors I got from this vendor are already rusty after only not even a year.

1 rubber boot was not properly installed thought no big deal it took me a bit installed but Came back off once i installed the part and greased it Will not be purchasing again Came with 2 nuts 1 castle nut 1 cotter pin 1 zirc fitting For each side Did not come with bolt thought that it would guess not

Don’t put too much grease in. It will push on the dust shield and rub against the rotor