Alligator Clips Electrical, 20PCS Preminum Test Leads with Crocodile Clips, 5 Colors Jumper Wires Kit with Testing Probes for Electrical Testing with Dual Ended Insulators for Circuit Connection

Wires are a little thin but good for testing computer wiring

Very versatile set of wires. High quality and very easy to use. Lightweight and a length that is easy to work with. I have primarily used these for up to 12v voltage applications, but they can be used for anything on down from that. Great price for these and super useful to have. Also work for crafts and as a makeshift tether for eyeglasses or earbuds. Can even be used as a necklace for ID tags.

Not bad clamps only thing is the rubber moves around on the ends makes it really hard to depress the clamp.

Never seem to have enough of these if you're a DYI person or you just need to extend a connection briefly.These are pretty decent for the money. The wires at least a foot or more, (more). The alligator clips are a real strong point, depends how you look at it. The springs in these gators are rigid, very rigid. I can't even recall when I've had any alligator clips that have this much tension & thus grip.Obviously these Jumpers are not for use with anything that pulls any real current, so if your planning anything more significant, buy a higher gauge jumper set.I tested all the sets for continuity and they all passed. I only mention that as the wire to clip is only clamped, not soldered, i'll probably hit them with solder per job, if im soldering @ the time. I'm not sure about the plastic boots yet, except they do what they should, stop an accidental short to something close to you're work area. That's good, but the springs are so strong and the boots, so slick, it's difficult to pinch to attach without pulling back the boot, then putting it back. A Small pair of needle nose pliers is advised, but not needed. Once the clips on, it's got plenty of grip, they'll most likely be as difficult to remove as to attach. (Needle nose) pliers or any small pliers work and makes set up & break down, effortless.Definitely recommend these for light jump & testing. They do what there designed to do, and if you do Over Amp them, there cheap enough to discard & replace. Keep the gator clips if you do melt the wires, they'll make great accessories for small soldering project. I'm surprised McGyver didn't have these in his pocket with the Swiss army knife & the duct tape. I'm just say'in...saying....Blackroadster1

I use these all the time when working on motorcycles and RV's. Very happy with these test leads.

The plastic sleeves that extend over the metal clip were thin and slippery. Whenever I would try to open the clip the cover would slip off. I ended up having to slide the cover back from the clip to use. Once I did this it worked for what was needed.

Used these to adjust actuator ready for replacement without wasting to much time or using other methods.

Not much, you can screw up on a product like this