ARTR 2" x 50' Titanium Exhaust Header Heat Wrap 2 Rolls with 20PCS 11.8 Inch Stainless Steel Locking Ties

A little time consuming but works well.

Love it

As I type this review, I am still pulling glass strands out of my hands (ouch). But the wrap went on well and there were no surprises to speak of.About half of x1 roll did the headers on my Honda CBR1100XX Blackbird and I wrapped them while still on the bike. I expect that they will keep the heat away from the radiator when at stoplights. Just in my initial test, I was able to bring the temps down significantly at idle by turning on the fan. 1st time I've ever dropped temp while sitting still!ARTR was nice enough to include some latex gloves, but they tore while I was working and I still ended up with glass fibers all over my hands. Go buy yourself a really nice set of latex gloves, or risk the curse of 1000 pin pricks for the next day.5 stars and I may just buy some additional metal zip ties and do our CB1000R headers as well.NOTE: It WILL smoke for about 7 minutes when you fire up your bike after install. Completely normal.

Well made.

After researching the products from the big stores I was a little concerned by the low price here but also not so much I didn’t want to chance it. Glad I did. Ran this only around the exhaust running under my flooring. In vehicle temps are way lower. I could boil water on my bare floorboard prior to installing this. Probably going to purchase more to wrap the remaining and will definitely purchase more for my other project. * they supply ties but the directions suggest using worm drive clamps instead. I had zero issues with their supplied ties. Follow the directions and soak prior to install. I had very little to zero air-borne fibers while installing. As directed, DO use a face mask. Fiberglass particles stay in your lungs until you’re in a coffin.

I used this to wrap my downpipe on my turbo charged miata. The driver side would get very hot during 30min drives. The transmission tunnel was always warm to the touch, through the carpet. After wrapping the downpipe, I barely feel any heat on the transmission tunnel now.Cons: This stuff is very itchy. I recommend wearing some neoprene/nitrile gloves when handling it. Something you can throw away. Do not handle this stuff with bare hands, or even leather gloves/mechanics gloves. The fibers will embed into the gloves, making them itchy to wear in the future. Also, every time I work near the wrapped downpipe, I get itchy. This is a product of the material, not necessarily the brand. If looking to wrap a motorcycle exhaust, I would look for a product that has these fibers under control. Just something to keep in mind.

Soak it in water, it will keep fiber and much easier to work when it wet

Looks good, doesn’t hold heat in