iNextStation Neon LED Strip Light 16.4ft/5m 12V DC 600 SMD2835 LEDs Waterproof Flexible LED NEON Light for Indoors Outdoors Decor [ Ice Blue | No Power Adapter]

Disappointed.I built a project which was 5 meter long as the company said about this led.But when recieved, it was 496 cm. I miss 4cm. This is huge.I was hoping getting more than less...Very disappointed.

I bought three colours for decorative lighting in a classic van. First, you must be very skilled to be able to solder wires on to the copper tabs. If you're only half decent, like me, there will be a learning curve since more than a split second of applied heat will burn the material. You will need a fine tipped iron and fine gauge soldering wire. Second, you must apply glue or silicon, even if you do an outstanding job soldering. This is because the rope gets warm when in operation, which causes the copper tabs to slide off the rope if the ends are not sealed. Finally, sharp bends will disrupt the internal connection resulting in no illumination past the bend. I was, however, very impressed with the brightness. The product works best if you only need one continuous piece without any sharp bends, in which case you can just use the wires that come attached to it and trim off what you don't need. In other words, the product works best if you don't need to do any soldering. Positive and ground are not reversible; there is a positive side and a negative side (don't mix them up!).

Like many other users, the supplied electrical connection broke right off just by handling and inspecting the rope.I had never intended to use the electrical connection, but decided to solder my own end. Even with soldering, my ends broke off because of the flexible material simply cannot hold any weight.The only solution I found was to solder the wires, then e6000 glue and plastic from bread bag clips (cut in half) to form an end. This was the *ONLY* way to make the solder joint work, otherwise the wire would rip right off the end.Soldering itself was extremely easy as long as you tin the wires and flux. I used CAT-5 networking wire (twisted pair) as the wire. Go to youtube and watch a video on soldering tips if you need.Other than that, these lights are very, very nice and I used it for a PC case.

Used the LED strip as ambient lighting in my Tesla Model 3 frunk. The light is a nice diffused light due to the "jacket" that holds the LEDs in - so no hotspots! Good price for the product. I just wish the wiring pigtail were a bit longer for tapping into the power source with.

Fonctionne très bien supert mou se plie bien jai utiliser des petit bout de allien tape pour le faire tenir et oubliez pas d’acheter un transfo 12vdc5 amp suggère le vendeur mais moi jai mesurer sur le 12.75vdc donne 2.2amp donc un transfo 3 amp ferait la job!!