SybaSteel Computer Stand for ATX Case with Adjustable Width and 4 Caster Wheels - SY-ACC65057

The casters that come with this stand couldn't handle the wight of my mid-tower PC (~60lbs). The wheels didn't turn but instead dragged across my floor. I modified it by replacing the original casters with 2" soft rubber ones and turned it into a much higher quality stand. A little elbow grease and a hacksaw was required to cut the bolt down on the new casters. 10/10 after mod.

Putting together was a bit difficult if you do not own actual tools, the tools given to you are a bit annoying to use.You also need two wrenches basically and they only supply one so I would recommend that you make sure you have a small wrench so it makes your life easier to tighten the bolts together.Other then that my rig is off the floor so it does as it says it would.

Works good, mind you I have a lighter pc gaming set up but I’d imagine if your pc is over 50 lbs this would be very hard to roll on carpet. Mine is around 25-30 Lb mark and it does exactly as intended. Sleek look and easy to build no instructions are needed

Doesn't work well with my PC. It doesn't allow my PC to vent as well. If it's not placed perfectly centered under PC it tilts slightly and doesn't roll well.

Had a major gaming rig built for my kid and it has to sit on floor. This makes me feel ok with that.