REEKON M1 Caliber Measuring Tool for Miter Saws – Eliminates Need to Measure & Mark Materials, Reduces Cut Time and Increases Safety, Measures Flat & Round Materials

I couldn't belive until I used it. The accuracy is so high and easy use. The material is high quality. I hope their new Tape measure comes out (the chip one) and I can ordered it immediately

Been using this thing for few years now. Simple and easy to use. Glad I purchase makes cutting to size great and if so it right get same length all the time. I would highly recommend if your looking but oneI would buy again

This is a nice little machine. Getting is calibrated sucks, I followed the instructions again and again and again and it kept saying I was a 1/16th off every time so what they don’t talk about is you have to measure the thickness of your saw blade and you need to enter that into the machine otherwise it will always be off. Now for the money I spent. It’s expensive this is not a homeowner tool this is a professional homeowner tool after my struggles and a lot of YouTube videos I finally got it dialed in. Time will tell if it’s making my life easier but my advice to the creator is to drop the price or provide a No BS lifetime warranty. It’s got your name on it and that’s all you need you will fix it for free at this cost. A tape measure is $20 dollars I’ve done a lot with a tape measure your going to have to try and convince me otherwise that your M1 tool can improve my life

Once you get this calibrated, measurements are spot on. Set up instructions and calibration are awful and incomplete. I found an independent YouTube video for setup that was complete and easy to understand.

Follow Up: since my first review, Reekon reach out and offered a refund. They then requested my address. Once I supplied my address they stopped responding. I believe this is a scam of sorts.This tool is very inaccurate. Never get the same measurement twice. All hype no accuracy. Save your money.

My husband Loves this product. He always knows exactly where it is!

If you are doing one or hundred cuts, this is nice for continuous accuracy.

I was not happy with this product and ended up returning it. I find the claims of vast speed improvements from using this tool to be overblown.Perhaps it's a "skill issue" as the kids say, but I had two main problems with this. First, you have to make sure to carefully slide the entire length of the board you are cutting under the wheel, making sure to keep the board against your saw's fence in order to get max accuracy. When you are making long cuts and sliding the bulk of an 8 foot board down the fence, that's easier said than done...at least for me it was. I found that it was faster for me to just measure with my tape and mark my boards, then I can put the boards quickly against my fence with my mark already near the blade.This also has an accuracy of 32nds of an inch. Typically, you would think that's a good thing. But as you approach your desired cut length, the finesse required to ease up to your measurement as the 32nds tick by was just too much for me to be efficient.I am an absolute novice, so if you are experienced, your experience may be different than mine. I cannot complain about the accuracy of the tool. Even though the calibration instructions were a little vague, I was able to setup my kerf on the device, and I was getting accurate cuts. My main complaint is simply about the purported time savings, which I did not personally experience.