PowerwerxPanelPole2, Panel Mount Housing for Two Anderson Powerpole Connectors with a Weather Tight Cover

A little pricey but works great. I didn’t really need the 12v cigarette plug that came with the cllena power bank so I replaced it with the power pole receptacle. It fit great! I used a rubber o ring to space it off the panel slightly so the rubber cap would have enough space to close securely.

This is from PowerWorx and the quality is good and works as expected.

Easy install because you only need to drill one standard hole. Negatives this is a very expensive option. Not really worth $30.00 after taxes. I built this into a LIFEPO battery module that I built to fit inside a Harbor Freight Apache 4800 case. I have built other battery boxes using a $9 power pole unit but I had to cut a square hole creating more work but looks just as good. If you need to save time this is the way to go by using this device.

I use various sizes of Anderson connectors I’m quite a few different projects, including RV automotive and solar. Highly recommend this product. In particular, I use this one going through my battery box on my RV to connect to my lithium ion phosphate batteries. I could jumper in a solar panel, or even my Starlink satellite without having to open the box. What’s even better is I can run a solar panel and have the Starlink at the same time because this has two ports. The waterproof cover works excellently.

PowerPole connectors are becoming the new standard in amateur radio for 12vdc equipment because they are so easy to install and allow such easy disconnection, move around equipment, take mobile, take/ setup outside on picnic table in backyard or local park. In club events it’s common to swap equipment around for others to get a feel for rigs they may be thinking about up-grading.But until now there hasn’t been a two sided PowerPole that was designed to mount on a portable ‘GoBox’ (grab & go heavy duty case with ham radio equipment already setup inside, sometimes with Lion battery already inside to immediately be ready. But we needed a thru the case PowerPole connection (on inside & outside) for both charging and/or attaching external power sources… solar panels, car battery, 120vac to 12vdc power supply. THIS IS WHAT HAS BEEN NEEDED!

Nice, useful connector but too expensive.

I added this to a 50ah, LiFePO4 battery box project I built for ham radio operations. It works great. The only issue I ran into was the tight quarters when running heavier gauge wiring for higher amp draw situations. (getting four 45amp PowerPole connectors with 10g wire in the back was tight!)

Easy to install for practically any project. Very useful for DIY radio projects.