Edge Supply Maple 3/4” X 50' Roll of Plywood Edge Banding – Pre-glued Real Wood Veneer Edging – Flexible Veneer Edging – Easy Application Iron-on Edge Banding for Furniture Restoration – Made in USA

I am building a set of drawers with 1/2" maple veneer plywood and used this edge banding in 3/4" to finish the top edges. I am thrilled with the results.Here is my installation process. I cut the banding a little long then I pressed it down with a travel iron (~$20 here on Amazon) set at about 2/3 its maximum temperature. It worked perfectly to activate the adhesive. Use a wood block to press down the edge banding while it is still hot. A minute or two later, longer is probably better, I used a putty knife to remove most of the excess on the sides. I have seen a lot of discussions online about using utility knives, chisels, files, and card scrapers to remove the excess, but this method worked very well for me. It takes a bit of practice (use a trial board or two first), but with the board on edge held in a vise hold the knife almost vertical, work it gently into the excess a half inch or so down the board, then still holding it almost vertical and at about a 10 degree angle away from the face of the board, run it down the edge to remove the excess. Come back the other way to remove the rest. The putty knife does not have to be that sharp, in fact it is better not too sharp to avoid damaging the board. After the excess is off the sides, sand off the remainder rounding over the top a bit. Only after removing the excess from the sides, fold the excess tabs at the ends down, tear the tabs off downward, and sand off the excess with downward strokes only to avoid pulling the banding off the board.

I made a cabinet out of plywood for my closet and used this to cover up the edge of the plywood. Took stain the exact same way as the plywood. Very easy to put on as well. I just used an iron and had no issues, sticks on very well.

This products was very, very good. If there are finger joints, which I am sure they are there, I didn’t see them. Great look and application was easy and neat. Great product.

You lose about 1.5 ft of the product because of the sticker they use to hold the roll together. But the wood is high quality and you can't see the seams at all, MUCH better than a previous purchase of the same product from Unimar.

I was initially hesitant, but this veneer exceeded my expectations! It resembles real wood and enhanced the aesthetics of the chest I made. Applying it was a breeze, and it has stayed firmly in place without any peeling issues. Highly recommended for a professional finish!

Once you get the hang of it, the backing comes off easily every time. The only material that sometimes gets pulled up a bit is MDF. Be careful with that. Otherwise, it works super good for plywood, softwood and hardwood.

Shara on YouTube recommended this product and I'm glad she did. I'd never worked with it much less heard of it before but it went on smooth and easy. I got a cheapo iron and set it to the highest setting and installation was a breeze. Sands nicely and takes conditioner and topcoat just fine.

Grainless veneer with minimal glue. It works in a pinch.