Master Airbrush Brand 0.3cm 2 Way Airbrush Splitter

Works great.

had to return

This fit my compressor perfectly. Now I have both airbrushes hooked up without the need to switch them out. I maintain perfect air pressure in each airbrush. I’ve had it for a while and there are no leaks where’s it’s connected.

I read the reviews that said the air leaks, however I purchased anyway because I have found in the past that the reviews weren't accurate due to people not using the items properly or just not following directions. However, in this case the reviews were right. It does leak are from the female end that connects to the compressor. I tried plumbers tape as suggested in one of the other reviews and that helped a little. So the compressor doesn't cut on as often as it did when connected without the tape. The problem seems to be that there is no rubber washer or insert in the female end to help seal the connection. So I would suggest searching for another product that has secure connections. The male ends connected to the hoses works fine but I would not buy this again.

There is nothing that bothers me more than to be seduced by a cheap price for an item that ends up not delivering on its most basic promises. This is no more than a hollowed out plastic "t" with three nuts attached that spin at their base. Therefore, I found it impossible to get an air tight fit. Moreover, because there are no cutoff valves you must use both connections or buy a cap to seal off the unused port. I know we all look for bargains - but in this case you are just throwing away your money or setting yourself up for another trip to UPS for the return. In my case I cannot make a return because of a failed attempt to seal the nuts with CA glue at the point they meet the plastic body. So, if it was disguised garbage before purchase it is certainly garbage now. Oftentimes, cheap can be expensive. I have lost my initial investment and will spend more money and time to get what I thought I was getting when I purchased this item.