Alla LightingNewest H8 H9 H11 CANBUS Decoders for Anti Flicker LED Fog Lights/DRL Bulbs Resistor Adapter Harness Kits/Fix Error Free Codes

Lucky break with being able to use existing car design to easily incorporate the resistor. I had concerns about mounting the resistor. In the pic you can see where an existing hole allowed me to use a screw with washer and then the resistor fit under the metal piece that holds the headlight to frame. Had to make one hole on back of light housing to run wire out. Extra length in wire is the secret.

This product simplified my previous wiring with one harness; on my Audi's fog lamps converting to LED bulbs required a separate CANBUS decoder and 6 ohms resistor. The length of wire from the plug to the decoder/ resistor allowed me to consider more mounting locations and to mount on a larger piece of metal to help dissipate heat. The size of the decoder/ resistor made it a little more of a challenge, but the performance so far has been very good (used it for the last couple weeks without a fault code tripping).

Work well, but lights are not so bright, i don't know that about lights or not I am not sure , but it's working,.

Product absolutely does not work. I bought Sealight H 11 LED bulbs for my 2010 Toyota Camry hybrid, but these bulbs kept flickering when you turned on the day running lights. Only in complete darkness, so when it had become completely dark, the LED lamps no longer flickered. Amazon.com recommended that I buy the Alla lighting decoder and they guaranteed that there would be no more flickering after connecting the decoder. I had the decoder connected professionally in a car garage, but after connecting the decoder instead of the H 11 LED lamps, the H 3 LED lamps (high beam) started to flicker when switching on the day running light mode. Either my Toyota Camry is not suitable for LED lighting or the Alla lighting decoder is just a worthless product that does not deliver what it promises to do.

Works as advertised no errors and easy to install plug and play a must have if you are up dating to LED

1.Heat - very big problem, this BURNT a hole On top of the fusebox of a Honda Odyssey.See the attached snaps, the plastic cover of the fuse box actually MELTED WITH THE HEAT, It could have burnt the fuses also and costed me MUCH MUCH MORE.I was lucky to have seen this, For a Honda Odyssey we need to remove the front bumper to replace the ALLA ballast, which is a ton of work so thank you for quadrupling my issue with a BAD PRODUCT.The good thing is that its ONLY ONE of them thats burning hot - i am Thankful for that - Rock bottom expectations.2. Did this fix the DRL - No- interesting to note is the DRL goes away if i turn headlights on as it must even without the Alla ballast.3. The first set of ballasts failed in a month and the second one burnt the fusebox cover.It seems to happen quite a bit- failure and overheating- you decide if its worth the risk.

Great product, tried others that did not cancel dashboard error message on my XC90. Good design and build quality.

This is the 4th decoder I have tried on my 2006 Volvo S40 and the only one that has worked so far. It does seem better made than the others I have tried, and I no longer have a bulb error on my dash.

Used this product briefly. It didn't prevent flickering and it got so hot it melted the velcro patches I used to attach it. Also burned my fingers when I touched it. Save your money.