AUDEXEN LED Fog Lights with DRL Compatible with Camry Highlander Corolla Prius, Passenger and Driver Side Led Fog Lamps Compatible with Lexus GS IS LX RX ES CT

The media could not be loaded. Its a fog light and will act as one. Not aggressive, but cool lighting at night. Note: when the DRL(ring light) is activated, the main fog light will turn off, both can't stay on at the same time. Liked it.Update: purchased on 5th February, 2021. I liked. Installed it on my toyota corolla. Now, transferred to my camry, and it's still working like champ. 29th December. 2021

I have a 2019 Toyota Camry SE and one of my fog lights died so i got this as replacement and they fit like a glove and work super good

Good lights

Does not fit the 2013 ES 300 Lexus. The only reason I give it such a low star you have to tear the entire bumper down a lot of work to get to the fog lights; they do not fit the pre-manufactured hole at all.

Foglights came with the wrong type of connector plug shells that spaces the pins/wire terminals too far apart. Fortunately, I had extra H11 connector shells available, which is the right type of connector for Toyota/Lexus that spaces the pins/wire terminals closer together.Once that is taken care of, the foglights will be plug and play with the factory foglight connector in your Toyota/Lexus.I used a relay wiring harness to connect the yellow DRL wire to connect it to a fusetap drawing power from a fuse that is only energized when the ignition is On, in the engine fusebox.I also put clear yellow vinyl over the foglights, because I like the extra contrast it gives, especially when the roads are wet. In addition, yellow stands out more during the day when used as DRLs.Edit: I'd classify these lights not as "foglights", but as "driving lights", because these throw a lot of light down the road. Unfortunately, they put out a lot of light above the cutoffs of the lowbeam headlights, causing glare issues to other drivers. When they are on, it's like driving around with the highbeams on. You can easily see that this is true by turning on your lowbeam headlights against a wall about 30 feet away from the front of your car, then turn on the foglights. You'll see that a lot more light is visible above the lowbeam headlight cutoff line with the foglights on. This is high angle glare, which bothers other drivers.Edit 2: I figured out how to reduce the glare problem, mentioned above. I got a sample sheet (4 x 8 inch) of black perforated vinyl, sold as one way privacy vinyl. The small holes in the vinyl film allow about 40 to 50 percent of the light to shine through, which is still bright, but cuts the glare down to an acceptable level IMO. I used a vitamin bottle cap as a template for my circle. I wanted to screen the middle, bright foglight but leave the outer DRL ring unblocked. You can see in one of the pictures how the brightest part of the light shining through the foglight outer lens is "screened" by the round piece of the perforated vinyl when the foglight is on.

This light are just very good, use it on Lexus ES300h 2014 and also on Camry 2012 very satisfied with this purchase.

The media could not be loaded. I like is sealed and mois is not gona get inside

Down side If I didn’t already have the wires ran it would have been a problem because it didn’t come with a wire kit. Up side they look great and where easy to install. Visibility at night increased and I can see like a lot farther down the road.