Toptekits 2 Port USB 3.0 A Female Screw Panel Mount to Motherboard 20 Pin Flat Cable Cord, 1.6ft/0.5m

Worked perfect for my custom SFF case. I was able to fold the cables over each other and put a 90 degree bend on the as well. Holding up great so far, worked perfect for my needs. Easy to install and fit perfect.

Using in older style desktop. Fast speeds. Can place each port in different places without problems. Am getting speeds equal to USB 3.2 GEN 2 THUNDERBOLT. USED ADAPTER TO CONNECT 2 USB 9 PIN CONNECTORS INTO 1 19 PIN USB 3.0 CONNECTOR.

I used this to replace the USB 3.0 ports on the I/O panel of a Corsair 400R case, since Corsair no longer sells the replacement cable. I used a razor knife to trim the ears off (soft plastic) and shorten the bodies to fit, then hot-glued them into place. They stick out about 2mm, but that's hidden by the dongles for my mouse and keyboard, which is what I use them for. Buttoned things up, and it works fine.

I purchased two of these to use them for a PC modding project. tested them both intensely with many different devices like wireless receivers dongles, USB WiFi adapters, Bluetooth USB adapters, USB 2.0 and USB 3.0 flash drives for about 3 days now and I didn't have any issue nor any error with them. strongly recommended for many DIY mods. the cable length is 20 inch (50cm) exactly which is one of my main reasons to purchase these instead of many others. the quality of the materials used for the ports and wires are very good and very well crafted. definitely buying these again for any similar future project.

One of the external USB ports on my case ripped out when it got stuck in a flash drive. this would cause a short and I had to take apart the I/O panel and remove both ports or I would get a USB short code and my system wouldn't start. I could have bought a replacement from Coolermaster but that was a lot more money and longer shipping. While this is not a direct fit since one of the screw holes didn't line up it was the correct depth. Drilled a small hole in the metal for the other screw and installed the assembly. Now I have front USB 3.0 ports again and these cables are more flexible than the stock cables

Worked well and I was able to fasten to a preexisting tower. Needed to buy an extension. Not long enough

It didn't work for my case but that's not the fault of the product. I was trying to replace a proprietary part and it just didn't fit. Oh well, better luck next time. The part itself works fine.

It should be fairly obvious that most people will need to mod the case or USB cables a little bit to make everything fit properly. My case had USB ports with a slightly smaller, hard rectangular shape. These have small "lips" that make them wider so I had to grind down the slots in my case a bit to make them fit. Overall good buy.

Very long time for shiping china post Very long time for shiping Very long time for shiping Very long time for shiping

to short it is 50cm from the neck to the neck

DELLのデスクトップパソコンのケースを流用して自作した時に、フロントIOのコネクタが汎用ではなくマザーに合わせた専用形状だったので、汎用品にするために購入。 マザー側、IO側一部小加工が必要でしたが、これで汎用ケースとして使えるようになりました。

PCケースのUSBポートの接触不良が頻発したため交換に使用。 普通に使えました。

自分のマザーボードでは使えなかったです。