PC Products PC-Pool Epoxy Putty, Moldable 4 oz Stick, Off White 41116 (Pack of 1)

Had a leak around one of our pool return jets. this epoxy stick was easy to use. Just cut off a section from the tube and kneed the two together until a consistent color. Placed the product around the underwater leak area and carefully molded into the area of the leak. It hardened underwater in about 10 minute and completely solved the problem. Did not have to drain pool down below leak. Excellent repair and solved the problem. Yes I recommend and very satisfied

This epoxy is the best ever! No more mixing liquid 2-part epoxies and wondering if you squirted out an equal amount of each, then having it drip all over. This epoxy is clay-like in consistency, so you just cut off whatever size you deem necessary, and knead it. It even can be applied under water.

I had a crack in my skimmer and usually I would make that type of repair by cutting the concrete and replacing the unit. Got the estimate for that ...and though it better to go with this product. Crack filled and no issues. No reason to go nuts to make this type of reparir.

It worked and it sealed the leak but it didn't last. Maybe I didn't get the surface clean enough for something but it didn't hold for more than a few weeks.

Had a leak between skimmer and tile. Drained down the water and cleaned. Formed a little snake of epoxy and put on crack and used my finger to smooth out. No more leak so far!!I didn’t try to use under water.

I bought 6 of these and felt bad and I should have stuck with my other favorite, Leakmaster Epoxy Stick, albeit more costly. This product does not cure well, remained sticky even after thorough kneading. I will not recommend this product.

This product was an excellent choice to quickly resolve a leak in my in-ground swimming pool.My leak was on the exterior of one of the 1½" Schedule 40 PVC pipes penetrating the side wall for the pump return jet.In my case the fitting for the jet nozzle was a friction fit to the pipe interior, so I slid out the jet nozzle so the junction between the 1½" PVC pipe and the cement / Diamond Bright wall was exposed.A utility knife was used to dig out any loose cement / Diamond Bright around the pipe prior to starting, increasing the leak slightly at this point.A suitable length of the epoxy rod was cut off, then mixed by hand until a uniform color was attained.That mixed epoxy was forced into the gap between the 1½" PVC and the cement / Diamond Bright, until I was unable to push any more into the gap.The leak was identified prior to the repair using liquid food coloring and a children's oral liquid medicine syringe. This permitted placing very controlled small drops of coloring in the water near the suspected leak, then watching the water flow forcing it through the wall gap. Once the epoxy repaired the leak, the food coloring demonstrated the leak was fixed.

It worked but I needed a better video on YouTube to make it work. The biggest issue was how much kneading was needed

Fantastic product. Used JB Weld's version before which is a nightmare to use. Super sticky trying to apply it under water and nearly impossible to shape.This is not sticky and very easy to apply and shape underwater. So pleased I bought 2 more units to have on hand.

I used this to stop a leak near the bottom of my stairs in our inground pool. Kneaded as instructed and forced it in where the leak was. Hardened up as it mentioned when cured and no leak! NOTE: If your pool is leaking water, save having someone come out by using food colouring in a syringe. Squirt a bit of the colouring around suspicious areas like stairs, jets, skimmer, light, etc. You will find the leak likely as I did...just look for the colouring to disappear and you know you found the leak.

as advertised, easy to mix epoxy and cured under water.

Excellent product

It is so easy to use, fixed my leaking pool filter! Saved cost of a service person.